Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Agate
User manual
Thank you for purchasing the Lightpro Agate.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Agate is an LED spot for outdoor use. The
fixture can be installed in a fixed underground.
This product may only be used as outdoor lighting in
combination with the Lightpro 12-volt system. Any
alterations made to the product may have consequences
for the safety, guarantee, and correct
functioning of the product and/or other parts of the
system.
SPECIFICATIONS
Product
Article number
Light source
Article number light source 6193011
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/Off
This product contains a light source with energy class F
PACKAGING CONTENT
[Figure A]
1 Fixture Agate
2 Tube
3 Hex key
4 Lightpro connector 137a
Lightpro Agate
102U
MR16 Led GU5.3 3W AC/DC 12V
3W
230 lm
3.000K
25.000
113 x 90 mm
IP67
-20 °C to 50 °C
0,5m
No
Replaceable
10.000
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
INSTALLATION
1. Dig the tube[2] into the ground at the desired location.
2. Pull the cable out through the hole in the tube[2].
3. Place the fixture [1] in the tube[2].
4. Connect the plug [4] of the fixture[1] to the main cable.
REPLACEABLE LIGHTSOURCE
[Figure B]
Proceed as follows in order to install or change the light
source:
1. Switch off the transformer.
2. Let the light source cool down for at least 5 minutes.
3. Unscrew the 4 screws with the Allen key[3] at the
bottom of the luminaire[1].
4. Replace the light source.
5. Tighten the 4 screws with the Allen key[3] again.
6. Switch the transformer back on.
Note: The rubber ring must be completely clean before
replacing the glass because of the water resistance.
Advertenties
Inhoudsopgave
