Advertenties
Beschikbare talen
Beschikbare talen
Before starting the installation:
Insert the memory card from
the adapter on the side of the
LCD display before you insert
the batteries. Ensure that the
marked side of the memory card
points forwards before inserting
the memory card. If you hear a
click, the card is locked and will
have been inserted correctly. You
can use an SD memory card of at
most 8 GB with this product. You
can remove a memory card as
follows: press the card and it will
stick out by a third so that you
can remove the card.
Next, insert the supplied
batteries in the Digital Door
Viewer before installing the
device on the door. Slide the
cover up and, next, outwards
to open it. Insert the batteries
following the indications of the
"+" and "-" signs on the cover.
Repeat the first step in the
reverse order to close the cover.
Installation instructions:
1. Replace the current Digital Door
Viewer or drill a hole with a
Ø of 14 mm at the required
height and insert the camera
from the outside. Insert the
white lock ring between
the camera and the door.
Ensure that the bell is at the
bottom and that the camera is
suspended perpendicularly.
2. Remove the 3M labels from the
fixing base and place the fixing
base over the end of the lens.
Screw the fixing cylinder in
place on the power tube of the
camera. This will keep the base
in its position on the door. The
arrow on the fixing base must
point upwards.
3. The metal wire must be
connected behind the display.
Surplus wire must be placed
carefully in the groove at the
back of the display.
4. Hook the display on to the
bracket on top of the base
and screw the display using
a small screw in the hole on
the bottom side of the display
housing. Hook and secure the
display housing and tighten the
screw.
Advertenties
