Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
eNet tastafdekking met radiografische ontvanger
Switch-on delay
Switch-off delay
Dim up ramp
Dim down ramp
Dimming adjustment time
Run-on time
Behaviour after the end of the
disabling function
32582713
J0082582713
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
On
Off
no change
Last value
Basic setting: No change
6/10
The load switches on after a
delay. Repeated switch-on
commands restart the delay
time. If the load has not yet
been switched on due to the
delay when a switch-off com-
mand comes, then the load
will remain off.
The load switches off after a
delay. Repeated switch-off
commands restart the delay
time. If the load has not yet
been switched off due to the
delay when a switch-on com-
mand comes, then the load
will remain on.
Time between switch-on and
reaching switch-on brightness.
The light is switched on at
minimum brightness and then
dimmed to the switch-on
brightness.
Note: If scenes are recalled or
switching uses logic modules,
the switch-on brightness is
approached using so-called
soft dimming (not configura-
ble).
Time until reaching minimum
brightness in case of switching
off (short operation). The light
is dimmed to minimum
brightness and then switched
off.
Note: If scenes are recalled or
switching uses logic modules,
the system switches off direct-
ly.
Time from minimum
brightness until reaching maxi-
mum brightness (dimming
speed).
As soon as a run-on time has
been entered, the actuator will
no longer remain on perma-
nently, but only for the length
of the run-on time. The run-on
time is restarted if actuation is
repeated. This parameter is
directly connected to the
"Manual switch-off of run-on
time" parameter.
Behaviour of the output when
a block is removed.
15.07.2016
Advertenties
Inhoudsopgave
