Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Select the desired position by means of the par-
ticle size regulator B2.4.
By turning the regulator clockwise, the selector
(B2.4c) moves and closes the opening, while it
opens if the regulator is turned anti-clockwise.
To use the bowl without selector, firmly grasp
the bowl body and use your other hand to rotate
the particle size regulator (B2.4) clockwise until it
is ejected from the upper part (B2.3).
OPERATING INSTRUCTIONS
Before each use, wash your hands thoroughly and clean your appliance as described in the
section "HYGIENE PREPARATION". During application, it is recommended to adequately protect
oneself from drips. This appliance is suitable for the administration of medicinal substances
(solutions and suspensions), for which aerosol administration is envisaged; such substances
must in any case be prescribed by a doctor. In the case of substances that are too dense, dilution
with suitable saline solution may be necessary, as prescribed by a doctor.
1. Insert the plug of the power cable (A6) into a mains socket corresponding to the voltage of the ap-
pliance. It must be positioned in such a way that disconnection from the power grid is not difficult.
2. Pour the medication prescribed by the physician into the lower part (B2.1). Insert the upper part
(B2.4+B2.3+B2.2) of the bowl into the lower part (B2.1), then close the bowl by turning the upper
part (B2.3) clockwise. Close the nebuliser by turning the upper part (B2.3) clockwise.
3. Connect accessories as indicated in the "Connection diagram" on the cover.
4. Set the bowl selector to the desired particle size as described
under "How to use the RF9 bowl".
5. Sit comfortably while holding the nebuliser in your hand, place
the mouthpiece to your mouth or use a nasal piece (if provided)
or mask. If you use the mask accessory, place it on your face as
shown in the figure (with or without the use of the elastic band).
6. Switch on the device by pressing the switch (A1) and inhale and
exhale deeply; after inhaling, it is recommended to hold your
breath for a moment so that the inhaled aerosol droplets can
settle. Then exhale slowly.
7. When the application is finished, switch off the device and disconnect it from the mains.
ATTENTION: If, after the therapy session, an obvious deposit of moisture forms inside the tube (B1),
detach the tube from the nebuliser and dry it with the ventilation of the compressor itself; this action
prevents possible mould growth inside the tube.
To facilitate the connection of the connection tube (B1) to the compressor unit, act on the end of it by
simultaneously rotating and inserting it, and for removal by rotating and extracting it.
11
-
+
B2.4
B2.1
Advertenties
Inhoudsopgave
