Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USER INSTRUCTIONS
USER INSTRUCTIONS
Button A is the control button (thermostat button).
Button B is the ignition button.
B
C
A
Lighting
Turn the word 'Pilot' on control button A to exactly
opposite point C, as shown above.
Press the control button to allow gas to flow to the pilot-
light. Now press the ignition button (B) several times to
ignite the pilot light. Press the control button for approx. 5
seconds to activate the safety device.
When the control button is released the pilot light will
remain alight. Now turn the control button to the left,
through LO to HI, to ignite the main burner. Set to HI, the
thermostat will adjust the required room temperature to
the maximum temperature, and set to Low, to the
minimum temperature.
You can adjust the required room temperature by setting
the control button to anywhere between LO
and HI. Set to 'Pilot', only the pilot light will burn.The
main burner will no longer ignite, not even at low
room temperatures.
Turning the heater off
Turn the control button (A) to OFF.The gas supply to
both the main burner and the pilot light will now be shut
off.
NB: If, for any reason, the pilot light goes out, wait a few
minutes before relighting it.
N.B.: If the flue spillage sensor is repeatedly
activated, a qualified gas installer should be
contacted.
16
Advertenties
Hoofdstukken
Inhoudsopgave
