Advertenties
Beschikbare talen
Beschikbare talen
COMMAND_CLASS_VERSION_V2
This command class is used to obtain information about the Shuttle LZ. The Z-Wave library type, the Z-Wave protocol version
and the application version will be reported.
Because this product supports version 2 it reports the additional information: hardware version and number of firmware targets.
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
This will report information about the manufacturer. This product will contain the manufacturer ID of Forest Group NL.
Manufacturer ID of Forest Group NL is 0x0207, the ID of this product is 39.
Because the version 2 is supported this command class can also be used to request the serial number of the device with the
DEVICE_SPECIFIC_GET command.
COMMAND_CLASS_DEVICE_RESET_LOCALLY
When the product is excluded manually the DEVICE_RESET_LOCALLY_NOTIFICATION command is sent to node associated in the
lifeline association group.
COMMAND_CLASS_SWITCH_ALL
The Shuttle LZ supports switch all functionality and therefore can be in included in a switch all broadcast.
If Shuttle LZ is configured to switch all mode:
0x00
: is excluded from all switch on/off functionality.
0x01
: is excluded from the all on but not the all off.
0x02
: is excluded from the all off but not the all on.
0xFF
: All on and all off are both included.
COMMAND_CLASS_POWERLEVEL
The Power level Command Class defines the RF transmitting power. This command is used to test the connectivity of a network.
This command class makes it possible for supporting controllers to SET/GET the RF transmitting power level of a node and test
specific links between nodes in the network.
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2
The Shuttle LZ supports OTA (Over-The-Air) update.
This means that it is possible to update your firmware using Z-Wave. To accomplish this a capable controller is needed.
10
Advertenties
