Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Do not fill detergent into the detergent
compartment more than required; otherwise
you can see whitish streaks or bluish layers
on glass and dishes and may cause glass
corrosion. Continued use of too much
detergent may cause machine damage.
Using little detergent can result in
poor cleaning and you can see whitish
streaksin hard water. See the detergent
manufacturer's instructions for a further
information.
4.9. Filling the detergent
Push the latch to open the dispenser and
pour in the detergent. Close the lid and
press it until it locks in place. The dispenser
should be refilled just before the start of
each programme. If the dishes are heavily
soiled, place additional detergent in the pre-
wash detergent chamber.
4.10. Using combined detergents
These products should be used according
to the manufacturer's instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
4.11. Rinse-aid usage
The rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If rinse aid dosage
setting set too low, whitish stains remains
on dishes and dishes do not dry and
washed clean. If rinse aid dosage setting
set too height, you can see bluish layers on
glass and dishes.
4.12. Filling the rinse-aid and setting
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX level
and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
In order to change the rinse aid level,
follow the below steps:
•
Open the door of the machine.
•
Turn on the machine, and press the
Programme button as soon as the
machine is turned on.
•
Hold down the Programme button until
all leds blink twice. Rinse aid setting
follows water hardness setting.
DETERGENT
•
The machine will display the last setting.
•
Change the level by pressing the
programme button.
•
Switch off the machine to save the
setting.
The factory rinse aid level setting is "4".
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
Level
1
2
3
4
5
EN - 11
Brightener Dose
Rinse-aid not
P1-9h LEDs are on
dispensed
1 dose is
P2-9h LEDs are on
dispensed
2 doses are
1/2-9h LEDs are on
dispensed
3 doses
3h-9h LEDs are on
dispensed
4 doses
6h-9h LEDs are on
dispensed
Indicator
Advertenties
Inhoudsopgave
