Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.
Remove the protective cap and attach the gas supply hose to the device (left screw
threads!). Firmly screw on the nut
with suitable tools for unproblematic
gas supply (Diagram 1).
6.
Connect the pressure regulator to the
gas bottle. Firmly screw the nut on so
that no gas leakage can occur. Make
sure when you install the gas bottle
that the gas hose is not bent or kinked. Avoid turned and pulled tension.
7.
Check that the device is correctly
attached to the gas bottle and
perform a complete gas leakage test
(see the description below in this
booklet).
8.
When you're sure everything is in
order, open the gas tap. (Diagram 2).
9.
Turn the regulator button to the
maximum position.
10. Now insert the plug into the socket.
Then set the power switch to I (on)
(Diagram 3). The ventilator will start
running.
11. Wait until the ventilator is running steadily and stable. Now press the right-hand
button of the gas valve and keep it
pressed down for 10 seconds. Then
with your left hand simultaneously
press the ignition button a few times
to ignite the device (Diagram 4).
12. After the gas starts burning, keep the gas valve pressed in for another 15 seconds.
After that, you can let go and the gas
will burn continuously (Diagram 5).
13. Now turn the regulator button until it
reaches the desired flame length, in
accordance with your desired heat
output.
14. To switch off the device, close the gas tap of the gas bottle and wait until the flame
goes out. Now switch the power switch to O (off) and remove the plug from the
socket. Finally, disconnect the gas supply hose from the gas bottle.
Attention! The device will remain hot for a while after use. Always remove the plug
from the socket when the unit is not in use.
15. If you have to change the gas bottle or want to use the device after a period of
storage, you must repeat the entire process, including the gas leakage test.
21
Advertenties
Inhoudsopgave
