Advertenties
Beschikbare talen
Beschikbare talen
INSTRUCTION MANUAL 12 VOLT LED FLOOR DIMMER 611072
The Tradim 12 volt LED floor dimmer is equipped with a built-in LED driver. The dimming
range can be adjusted with the slider. Follow the steps carefully to connect and set the dimmer.
4
min.
0,5 mm
5 mm
15 mm
3
5
A. CONNECTING THE 12 VOLT LED FLOOR DIMMER:
1. Unplug the lamp from the wall socket.
2. Strip the wires (core diameter minimum 0.5 mm², maximum 0.75 mm²) from both the lamp and the
power supply (No. 3 and no. 4 in the drawing above).
3. Unscrew the dimmer and remove the interior (PCB) from the housing including the switch.
4. Insert the stripped brown and blue wires for the power supply and lamp into the relevant part of the
terminal block (No. 6 in the drawing) and tighten the screws.
5. Loosen the strain relief screws and remove them from the housing.
6. Place the interior, including cords, back into the housing and ensure that the slide is at the bottom.
Put the switch (with wires) back in place.
7. Re-install the strain reliefs, clamp all cords under the strain relief and tighten the screws of the
strain relief.
8. Replace the cover - making sure that the knob (No. 5) fi ts into the transit and that the slider (No. 2) is
at the bottom (test if the slider is works accordingly).
B. SETTING MINIMUM DIMSTAND 12 VOLT LED FLOOR DIMMER (LAMP DIMMING WITH SLIDE):
1. Push the slider (No. 2) to the minimum position. The lamps must not be switched off in the
minimum dimming position. If the lamp does not have the desired minimum dimming position,
simply adjust it with the potentiometer (No. 1) on the printed circuit board. Continue with B2.
2. Unplug the power cord and unscrew the dimmer.
3. Adjust the potentiometer (No. 1).
4. Close the dimmer and put the plug in the wall socket.
5. Repeat step B1.
PAY ATTENTION! NEVER PLUG THE PLUG INTO THE SOCKET IF THE DIMMER IS STILL OPEN!
CHANCE OF ELECTRIC SHOCK!
TECHNICAL DATA TRADIM 12 VOLT LED FLOOR DIMMER:
• Power range 1-25W / VA dimmable. The dimmer works on 230V AC / 50Hz and has IP20. The dimmer
output voltage is 12V DC PWM (pulse with modulation).
• Suitable for dimming dimmable LED lamps.
• The on the sticker (bottom of dimmer) indicates that there is no voltage on the lamp in the off position!
• Use the LED fl oor dimmer indoors at a temperature between 0-40ºC.
• Use in non-condensing rooms with a relative humidity between 10% and 90%.
• The manufacturer is not liable for damage caused by incorrect use or improper installation of the dimmer.
• The warranty period is 2 years after the purchase date, to be demonstrated by means of your
purchase receipt.
REQUIREMENTS FOR CONNECTING THE LED FLOOR DIMMER:
• Small Phillips screwdriver • Small screwdriver (voltage fi nder) • Thread stripper
Keep these operating instructions in a safe place in case it is needed for reinstallation!
TRADIM Aalsbergen 9, 6942 SE Didam NL www.tradim.nl
2
1
Adjustable screw
2
2
Dimming slider
3
Cable insulation
6
(-)
12V to lamp
(+)
(L) brown
(N) blue
1
-
4
Core diameter
5
On/off push button
6
Connection diagram
to plug/socket
+
Advertenties
