Advertenties
Beschikbare talen
Beschikbare talen
Using the dishwasher
Status light
The status light at the bottom on the dishwasher provides information by means of 3 different colours.
Blue - Load more
The program has started, but you can still load more dishes.
Red - Do not load
You should not load more dishes (risk of poorer dishwashing result).
A flashing light indicates that the door has been opened while a program is in progress. If it flashes
when the door is closed, an error has occurred. See the chapter Troubleshooting.
Green - Unload
The dishwashing program is finished. The status light stays on for 15 minutes.
Stopping or changing a program
If you want to change program after starting the dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if the lid of the detergent dispenser has opened.
Then select a new program, press Start/Stop and close the door.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a
while, the dishwasher continues the program.
If the dishwasher is turned off due to a power failure
If the dishwashing program was not finished, the interrupted program continues when power is
restored.
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than 2
minutes.
Once the program has finished
The end of the program is indicated by one short signal from the buzzer. The chapter Settings
describes how to change this function.
Moreover, the end of the program is indicated by the status light turning green.
20
Status light
Advertenties
