* Aansluitschema voeding
De volgende werkzaamheden zijn levensgevaarlijk en kunnen leiden tot ernstige verwondingen en schade aan het
product of gebouw. De aansluitingen dienen dan ook door een erkende installateur uitgevoerd te worden.
Zorg ervoor, voordat je met de montage van de bedrading begint, dat de stroomaanvoer is afgesloten.
Systeem bedrading:
Bedradingen die niet gebruikt worden, graag beschermen met isolerende krimphoezen of tape naar gelang de
toepassing. De groene en gele bedrading zijn beide voor het signaal, echter wanneer je de deur op slot zet, dan
kan de aansluiting op groen niet de deur openen, de aansluiting op geel kan de deur openen en sluiten (slot).
* Externe aansturingen
Bewegingsmelder:
Unit
zwart
geel of groen
rood
Schakelaar:
Unit
zwart
geel of groen
Disclaimer
The original language of these instructions are English. The airborne noise of the system under normal operating conditions does not exceed
70dB (A). PC Henderson nor the motor unit manufacturer take responsibility for failure to use Good Working Methods in building the frames to
be motorized or for any deformation occuring during use. PC Henderson and the motor declines all responsibility in the event of component
parts being fitted that are not compatible with the safe and correct operatio
parts must be used.
This installation is intended for professionally competent personnel only. Installation, Electrical connections and adjustments must be
performed in accordance with Good Working Methods and in compliance with applicable regulations. Before installing the product, carefully
read the instructions. Bad installation could be hazardous.
Before installing the product, make sure it is in perfect condition. Do not install the product in an explosive environment and atmosphere;
gas or inflammable fumes are a serious risk hazard. Before installing the system, ensure all structural changes relating to safety clearances
and protection or segregation of all areas where there is a risk of being crushed, cut or dragged, and danger areas in general. Make sure the
existing structure is up to standard in terms of strength and stability. Each installation must clearly show the identification details of the
motorized door or gate. Apply hazard area notices required by applicable regulations. he electricity supply must be isolated at its source
before attempting installation or maintenance.
Rood:
Zwart:
Groen:
Geel:
Wit:
Bruin:
PrimeMotion
groen + wit
geel
bruin
Bediening
blauw
bruin
n.
24v stroom
GND
Signaal
Signaal (geschikt voor slot)
Safety beam
Bluetooth password reset
For repairs or replacements of products only original spare