Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Whirlpool 10 Button - User Manual
EN
when the water temperature is at least 1 degree lower than the set temperature. When the water reaches the set
temperature the heater will stop heating untill the temperature drops again. When the heater is on, you can touch the
"
"button to turn it off and so will the backlight of the button. If the thermostat function is on and the water level
drops below the minimum water level it will turn off as well. To set the temperature you can use the "
the heater is on. You will then see the temperature appear on the screen and you are then able to increase the
temperature with the "
ATTENTION: The heater is meant to keep the bath water at a certain temperature level and not to heat up the
water from cold to warm.
4.1.8
Dry function.
When the system is on and there is no water in the bathtub, you can touch the "
The dry function goes from level 1 to level 5 for a period of 15 seconds each step, once level 5 has finished the dry
function stops. This whole dry cycle takes 75 seconds. During this dry function the "
emptying the bath the auto dry function will initiate automatically after 15 minutes. The "
start the dry-blow program. When the auto dry program has finished the "
5.0
Whirlpool Jets
5.1
Aero jet
As the word Aero already indicates, this is a jet for air flow. The air swirls through the water, which gives a
relaxing effect. The air from the aero jet opening enters the bath with a certain speed. The air may
therefore be perceived as cold. The jet house itself becomes somewhat warm.
5.1.1
Sparkle aero jet
The Sparkle aero jet has a chrome surface finish. This jet also produces a finer bubble compared to the
other aero jets.
5.1.2
Flat aero jet
The Flat aero jet has a chrome surface finish. To clean the jet, the inner part can be taken out with a
small screwdriver.
BE AWARE: Be very careful not to damage the chrome surface. After cleaning the jet house, the inner
part can be pushed back. The inner part is clamped by an O-ring.
5.2
Hydro jets
Hydro jets have a mixed flow of water and air. This results in a powerful ray with a massaging effect. The
function of the types of jets are explained below.
ATTENTION: Because some type of jets can be closed by turning, it is possible to close the jets while
the motor is running. Don't do this and make sure at least one closable jet is open at all time. Otherwise
the motor can get overheated because of too much pressure.
The Lux hydro jet has a complete chrome surface finish. The flow through the jet can be directed
stronger or softer. By turning the inner part of the jet by hand the flow can be adjusted. When the inner
part is turned clock wise, the flow will be less heavy.
"button and decrease it with the "
"button.
"button will turn off automatically.
-11-
"button when
"button to start the dry function.
"button is blinking. After
"button will be on and
Advertenties
Hoofdstukken
Inhoudsopgave
