Inhoudsopgave
Advertenties
MEC 2684ES / 3084ES SpeedLevel
918
4
6
1
INSPECT MACHINE AND MAKE SURE THAT IT IS OPERATING PROPERLY,
THAT ALL NAME PLATE AND SAFETY AND CONTROL DECALS ARE IN PLACE
AND LEGIBLE, AND THAT THE MACHINE IS IN ACCORDANCE WITH THE
MANUFACTURER'S MAINTENANCE REQUIREMENTS CONTAINED IN THE
OPERATION AND MAINTENANCE MANUAL AND THE DAILY SAFETY CHECKLIST.
OPERATE MACHINE WITH EXTREME CAUTION. WATCH FOR OBSTRUCTIONS
WHICH MAY STRIKE PLATFORM, PERSONNEL, CONTROLS, OR MACHINE.
OPERATE CONTROLS SLOWLY FOR SMOOTH PLATFORM MOTION.
OTHER HAZARDS
FOR DRIVING WITH PLATFORM LOWERED:
1. DO NOT EXCEED PLATFORM LOAD CAPACITY.
DO NOT EXCEED MAXIMUM PLATFORM OR
2. DO NOT EXCEED MAXIMUM SIDE FORCE AND
EXTENSION LOAD LIMIT CAPACITY.
MAXIMUM NUMBER OF OCCUPANTS.
LOAD TO BE UNIFORMLY DISTRIBUTED.
PLACE LOAD NEAR CENTER OF PLATFORM
3. DO NOT USE WITHOUT GUARD RAILS IN PLACE,
AND ENTRY GATE PROPERLY SECURED.
WHEN POSSIBLE.
4. DO NOT USE IF WORK PLATFORM IS NOT WORKING
PROPERLY OR IF ANY PART IS DAMAGED OR WORN.
DO NOT DRIVE ON SIDE SLOPE IF PLATFORM
IS OVER 5% OFF LEVEL.
5. DO NOT USE NEAR MOVING VEHICLES OR CRANES.
6. DO NOT STAND OR SIT ON GUARDRAILS,
DO NOT DRIVE UP OR DOWN A GRADE OF
ALL PERSONNEL SHALL ALWAYS MAINTAIN FIRM
OVER 40%.
FOOTING ON PLATFORM FLOOR.
7. DO NOT USE WHILE UNDER THE INFLUENCE OF
ALCOHOL OR DRUGS.
8. DO NOT OVERRIDE SAFETY DEVICES.
FOR DRIVING WITH PLATFORM ELEVATED:
9. DO NOT LEAVE MACHINE UNATTENDED WITH KEY
IN THE SWITCH.
DRIVE ONLY ON A SMOOTH, FIRM, AND PLANAR
10. DO NOT RAISE PLATFORM WHILE MACHINE IS ON
SURFACE FREE OF OBSTRUCTIONS.
A TRUCK, FORKLIFT, OR OTHER DEVICE OR VEHICLE.
11. DO NOT USE LADDER, SCAFFOLDING, OR OTHER
DO NOT EXCEED MAXIMUM PLATFORM OR
DEVICES TO INCREASE SIZE OR WORKING HEIGHT
EXTENSION LOAD CAPACITY.
OF PLATFORM.
12. DO NOT ENTER OR EXIT PLATFORM WHILE IN MOTION.
LOAD MUST BE UNIFORMLY DISTRIBUTED.
13. DO NOT RECHARGE BATTERIES NEAR
SPARKS OR OPEN FLAME, BATTERIES EMIT
IF TILT WARNING LIGHT ILLUMINATES OR
HIGHLY EXPLOSIVE HYDROGEN GAS.
TILT ALARM SOUNDS LOWER PLATFORM
14. DO NOT PERFORM SERVICE ON THE MACHINE WITHOUT
AND RE-LEVEL
PROPERLY SUPPORTING ELEVATING ASSEMBLY.
USE EXTREME CAUTION.
15. DO NOT ATTACH OVERHANGING LOADS OR
INCREASE PLATFORM SIZE.
IMPROPER OPERATION OF THIS MACHINE
COULD CAUSE DEATH OR SERIOUS INJURY.
8
91869
WARNING
SHEET LOADING GATE MUST BE IN LOCKED POSITION
BEFORE OPERATING FROM PLATFORM.
PLATFORM ENTRANCE MUST BE PROPERLY CLOSED AND
ALL GUARDRAILS PROPERLY IN PLACEAND SECURED
BEFORE OPERATING FROM PLATFORM.
FAILURE TO FOLLOW INSTRUCTIONS COULD CAUSE
DEATH, PERSONAL INJURY AND PROPERTY DAMAGE
CONTROL MODULE
12
91931
Model 3084 -- 91848
13
PLATFORM CAPACITY
1500 LBs (680kg)
91848
14
Model 2684 -- 92122
PLATFORM CAPACITY
1700 LBs (770kg)
92122
15
9052
92089
16
19
18
90750
90751
20
POWER MODULE
8779
21
Gebruikershandleiding MEC 2684ES & 3084ES
MEC Aerial Work Platform - Europe
www.mecawp.eu
9
1
845
2
YOU MUST NOT OPERATE
THIS MACHINE:
UNLESS YOU HAVE BEEN AUTHORIZED TO
USE AND TRAINED IN THE SAFE OPERATION
OF THIS MACHINE.
TRAINING INCLUDES COMPLETE KNOWLEDGE OF
THE SAFETY AND OPERATION INSTRUCTIONS
CONTAINED IN THE MANUFACTURERS MANUAL,
ANSI MANUAL OF RESPONSIBILITIES, YOUR
EMPLOYERS WORK RULES AND APPLICABLE
GOVERNMENTAL REGULATIONS.
AN UNAUTHORIZED AND UNTRAINED OPERATOR
SUBJECTS THEMSELF AND OTHERS TO
DEATH OR SERIOUS INJURY.
ELECTROCUTION HAZARD
THIS MACHINE IS NOT INSULATED
MAINTAIN SAFE CLEARANCE FROM ELECTRICAL
LINES AND APPARATUS. YOU MUST ALLOW FOR
MACHINE SWAY, ROCK OR SAG AND ELECTRICAL
LINES SWAYING.
THIS MACHINE DOES NOT PROVIDE PROTECTION
FROM CONTACT WITH OR PROXIMITY TO AN
ELECTRICALLY CHARGED CONDUCTOR.
YOU MUST MAINTAIN A CLEARANCE OF AT
LEAST TEN (10) FEET BETWEEN ANY PART
OF THIS MACHINE OR ITS LOAD AND ANY
ELECTRICAL LINE OR APPARATUS CARRYING UP
TO 50,000 VOLTS. ONE FOOT OF ADDITIONAL
CLEARANCE IS REQUIRED FOR EVERY
ADDITIONAL 30,000 VOLTS OR LESS.
DEATH OR SERIOUS INJURY
WILL RESULT FROM CONTACT
OR INADEQUATE CLEARANCE
9
Model 3084 -- 91944
MAXIMUM PLATFORM CAPACITY
EVENLY DISTRIBUTED
680 kg
91846
5 PERSONS
Model 2684 -- 92121
91869
6873
HYDRAULIC OIL
6873
17
90732
WARNING
DO NOT POWERWASH OR
SPRAY ELECTRONIC
COMPONENTS OR
CONNECTORS.
MOISTURE MAY CAUSE
DAMAGE AND/OR
ERRATIC OPERATION
90732
91956
90726
22
WARNING
EACH REPLACEMENT BATTERY MUST WEIGH
A MINIMUM OF 60 POUNDS / 27.3 kg
FAILURE TO MEET MINIMUM WEIGHT
REQUIREMENT MAY CAUSE MACHINE
INSTABILITY.
90726
PLATFORM
3
90733
TIP-OVER HAZARDS
DO NOT DRIVE NEAR DROP-OFFS,
HOLES, OPEN ELEVATOR SHAFTS,
AND LOADING DOCKS
5
90718
DO NOT ELEVATE PLATFORM ON
UNEVEN OR SOFT SURFACES
DO NOT DRIVE ONTO UNEVEN OR
SOFT SURFACES WHEN ELEVATED
DO NOT RAISE PLATFORM IN
WINDY OR GUSTY CONDITIONS
DEATH OR SERIOUS INJURY
WILL RESULT FROM IMPROPER
USE OF THIS EQUIPMENT
91845
91849 (2 PLACES)
7
DISTANCE FROM GROUND TO LADDER WILL VARY WITH GROUND VARIATIONS.
WARNING
MAXIMUM
WIND SPEED
12.5 M/S
45 KM/H
MAXIMUM
SIDE LOAD
400 N
91944
10
8606
CONTROL MODULE
AND
POWER MODULE
FRONT AND REAR
23
8502
(4 PLACES)
(not required for Foam Filled tires)
INFLATE TO TIRE
MANUFACTURER'S MAX.
SPECIFICATIONS
OR SEE
SERVICE MANUAL
8502
(4 PLACES)
8519
24
WARNING
REPLACE TIRES WITH MANUFACTURER'S
EQUIPMENT ONLY.
FAILURE TO USE MANUFACTURER'S
TIRES MAY CAUSE MACHINE INSTABILITY.
REFER TO MAINTENANCE MANUAL FOR
REPLACEMENT PART NUMBER.
8519
33
(4 PLACES)
Model 3084RT -- 91946
Model 2684RT -- 92229
MAX
3175 lbs
1440 kg
91946
31
91553
MFG. DATE
XX/XX
ELECTRICAL VOLTAGE
MAX. PLATFORM CAPACITY INCLUDING PERSONS
XXX kg = X PERSONS + XXX kg EQUIPMENT
XXX kg = X PERSONS + XXX kg EQUIPMENT
MAX. MANUAL FORCE
MAX. DRIVE HEIGHT
MACHINE WEIGHT
XXXX LBS
X X FT
X.X m
XXXX kg
MAX. GROUND
MAX. PLATFORM HEIGHT
MAX. WIND SPEED
PRESSURE PER WHEEL
X X FT
X MPH
X.X m
X m/s
THIS MACHINE HAS BEEN CONSTRUCTED IN ACCORDANCE WITH SECTION 4 OF ANSI A92.6-2006 COVERED BY US PAT. #5,476,050 & CANADIAN PAT. #2,115,870
Veiligheidsstickers
4
7155
MANUALS INSIDE
LOCATE CONTROL BOX HERE
FOR NORMAL OPERATION OF THIS UNIT
7155
90733
INSIDE DOCUMENT CASE
CHECK DISTANCE BEFORE LEAVING PLATFORM.
91849
32
THIS MACHINE IS NOT INSULATED!!! DEATH OR SERIOUS INJURY will result
from contact with or inadequate clearance from any electrically charged conductor.
91325
MINIMUM CLEARANCES FROM POWER LINES
CLEARANCES FOR OPERATING ELEVATING WORK PLATFORMS NEAR
Australia
OVERHEAD POWER LINES ON POLES
FOR THE PLATFORM OR PERSON IN THE PLATFORM
only
SPOTTER
REQUIRED
BETWEEN
OPEN
3-6.4M
AREA
OUTSIDE
OF
POWER
6.4M
LINES
OF
POWER
LINES
OPTION
8605
11
CERTIFIED LANYARD
ANCHORAGE POINT
UPPER CONTROLS
91934
26
25
90729
28
91932
27
7156
7156
MAX
3065 lbs
1390 kg
92229
BASE
MODEL NUMBER
SERIAL NUMBER
MODEL YEAR
XXXXXX
XXXXXXXXX
20XX
11026730
XX VOLTS
(4 PLACES)
XXX LBS
XXX N
MAX. HYDRAULIC
MAX. LOAD
SYSTEM
PER WHEEL
PRESSURE
X.X PSI
XXX LBS
XXXX PSI
X.X kg/cm²
XXX kg
XXXX bar
91553
6
91850
(4 PLACES)
91850
DANGER
POWER LINES WHILE IN OPERATING MODE
OVERHEAD POWER LINES ON TOWERS
NO GO ZONE
NO GO ZONE
FOR THE PLATFORM OR PERSON IN THE PLATFORM
ANYWHERE ABOVE POWER LINE
ANYWHERE ABOVE POWER LINE
AND
AND
WITHIN 3M EACH SIDE
WITHIN 3M EACH SIDE
AND
SPOTTER
SPOTTER
AND
SPOTTER
3M FROM THE BOTTOM
3M FROM THE BOTTOM
REQUIRED
REQUIRED
REQUIRED
SEE SPECIAL PROVISIONS
BETWEEN
BETWEEN
SEE SPECIAL PROVISIONS
BETWEEN
OPEN
OPEN
OPEN
3-6.4M
8-10M
8-10M
AREA
AREA
AREA
OF
OUTSIDE
OUTSIDE
OF
OF
OUTSIDE
3M
3M
POWER
POWER
POWER
6.4M
8-10M
8-10M
LINES
LINES
8M
8M
LINES
OF
OF
OF
POWER
POWER
POWER
3M
8M
LINES
LINES
LINES
91325
(6 PLACES)
8605
91934
91932
BOOM
29
91870
30
11026730
ART_3248
40
800440/V1.0
Advertenties
Inhoudsopgave
