Download Inhoudsopgave Inhoud Print deze pagina

Disclaimer - Henderson Evolve M2 Montagehandleiding

Inbouwset
Verberg thumbnails Zie ook voor Evolve M2:
Inhoudsopgave

Advertenties

7. Disclaimer

Please note
The original language of these instructions are English.
The airborne noise of the system under normal operating conditions does not exceed 70dB (A).
PC Henderson nor the motor unit manufacturer take responsibility for failure to use Good Working Methods in building
the frames to be motorized or for any deformation occuring during use. PC Henderson and the motor declines all
responsibility in the event of component parts being fitted that are not compatible with the safe and correct operation.
For repairs or replacements of products only original spare parts must be used.
General Safety Precautions
This installation is intended for professionally competent personnel only. Installation, Electrical connections and
adjustments must be performed in accordance with Good Working Methods and in compliance with applicable
regulations. Before installing the product, carefully read the instructions. Bad installation could be hazardous.
The packaging material (plastic, polystyrene, etc.) should not be discarded in the environment or left within the reach of
children, as these are a potential source of hazard.
Before installing the product, make sure it is in perfect condition. Do not install the product in an explosive environment
and atmosphere; gas or inflammable fumes are a serious risk hazard. Before installing the system, ensure all structural
changes relating to safety clearances and protection or segregation of all areas where there is a risk of being crushed,
cut or dragged, and danger areas in general.
Make sure the existing structure is up to standard in terms of strength and stability.
Each installation must clearly show the identification details of the motorized door or gate.
Apply hazard area notices required by applicable regulations.
The electricity supply must be isolated at its source before attempting installation or maintenance.
Installer responsibility
The installer should provide technical documentation once the installation is complete, this should include:
-
EC declaration of conformity with machinery directive
-
Installation manual
-
Maintenance / Trouble shooting guide (supplied in the drive unit manufacturer operation manual)
-
The installer is responsible for affixing final CE mark upon the installation
Manufacturers Declaration of Incorporation
Manufacturer: PC Henderson Ltd, Durham road, Bowburn, Durham, DH6 5EN. Telephone: 0191 3777245, Fax: 0191 3773166.
Hereby declares that the electromechanical automatic door operating systems Evolve, Evolve Glass, Evolve SIM are
intended to be incorporated into machinery or to be assembled with other machinery to constitute machinery covered
by directive 2006/42/EC. It is in conformity with the provisions of the following directives: Electromagnetic Directive
2004/108/EC & Low Voltage Directive 2006/95/EC.
The authorized representative located within the community is: Fergus Pickard, Product Development Director, PC
Henderson Ltd, Durham Road, Bowburn, Durham, DH6 5EN. The above named undertakes to transmit in response to a
reasoned request by national authorities, relevant information on the partly completed machinery.
Fergus Pickard, Product Development Direct. Bowburn, Durham 19/10/17.

Advertenties

Inhoudsopgave
loading

Gerelateerde Producten voor Henderson Evolve M2

Inhoudsopgave