Advertenties
Beschikbare talen
Beschikbare talen
• Do NOT disassemble, repair or restore the electric blanket. For your own safety, the blanket should only be repaired by authorized service
personnel. Check both the power cord and plug regularly for signs of damage or wear. If these are present, DO NOT use the blanket and have it
replaced or repaired.
• When the electric blanket is on, DO NOT use it near a bathtub, shower, (laundry) tub filled with water or swimming pool. DO NOT allow the
device to come into contact with water and/or liquids, for example by spilling a cup of coffee on the device. If this happens, stop using the device
and contact us immediately!
• If you are not using the blanket, always turn it off and unplug it.
• Keep the device away from moisture, heat, rooms where the temperature is relatively high.
• DO NOT cover the remote control when the blanket is on. Never place a pillow or blanket on or against the control panel. This may cause a fire
hazard, electric shock, personal injury or damage to the unit.
• When using adjustable bed: make sure the blanket cannot wrinkle and the control panel is not covered when adjusting.
• If the product is NOT responsive after it is turned on (i.e. the display screen does not illuminate), check that the plug is properly seated in (a
working) outlet. If the plug is properly inserted, the electric blanket is defective. In that case, do not use the blanket and contact us!
Use and operation
• Plug directly into an electrical outlet (220V-240V) Do not extend! Make sure there is an electrical outlet nearby and that the cord is not in a place
where people can trip over it. The blanket should only be used with the controller provided.
• Place the blanket in a safe environment as mentioned in the instructions. Turn on the remote control by sliding the ON/OFF button upwards. The
display turns on, counts up from 1 to 9 as the initial screen and then shows 0 (stand-by mode) First, choose the desired temperature using the
temperature button (6 heat settings) Then choose the desired time to automatically turn off using the timer button (1-9hrs) The unit will
automatically turn off after the set time (1-9hrs) The blanket will automatically turn off after 3 hours if no timer is set.
controller with display will remain on after the timer automatically turned off (setting 0, stand-by mode) If you are not using the blanket or
are not around, turn it off with the ON/OFF button and always unplug it to reduce risks!
• The display showing the active temperature setting will flash when the blanket is heating up. If the display does not flash, the blanket is at
temperature. This refers to the overheating protection that regulates/maximizes the temperature.
Prolonged (long-term) use on high setting can cause burns, only settings 1 to 2 are suitable for continuous use.
Always set the electric blanket to maximum temperature setting 2 setting before going to sleep, with a set timer of 2 hours.
• Let the blanket cool completely before folding and storing it. Also, do not fold the blanket too tightly. Store the blanket in its original packaging,
in a dry and clean place. Be careful not to damage the power cord when folding it.
Maintenance and storage
Warning: The blanket should only be washed by hand! Unplug the electric blanket and let it cool for at least 10 minutes before cleaning.
Disconnect the plug and control panel from the blanket (using the click system at the end of the blanket) You can remove small stains with a damp
cloth or sponge and some detergent. Wash the blanket by hand to remove large stains.
blanket (click system) where the plug goes in does not get wet! Use lukewarm water (max. 30°) and mild detergent and squeeze the blanket
gently. Rinse the blanket several times to rinse out all the detergent. Let the blanket air dry, DO NOT put the blanket in the dryer, DO NOT use a
hair dryer or other dryer and DO NOT iron it. Only use the blanket when it is completely dry again.
Always allow the blanket to cool completely before folding and storing it. Do not fold the blanket too tightly. Store the blanket in its original
packaging in a dry and clean place. Take care not to damage the power cord when folding it. Also, do not place any objects on the electric blanket
when it is stored. Also, do not store the blanket in extremely high or low temperatures.
Warranty and repair conditions
If you have any questions regarding the product, please do not hesitate to send us an e-mail at info@flowm.nl We provide a 2-year warranty on
our products. The customer must be able to show proof of purchase and the warranty must be asserted within a period of 2 years from the date of
purchase. Please note that the warranty does not apply: for damage caused by improper use or repair; for parts subject to wear and tear; for
defects known to the customer at the time of purchase; for defects caused by the customer's own fault; for damage caused by third parties.
Excluded from warranty and/or liability are: all (ancillary) damages caused by improper use e.g. non-compliance with the operating instructions;
damages resulting from repair or intervention by the purchaser or an unauthorized third party; parts subject to normal wear and tear. A liability for
direct or indirect consequential damage caused by the product is also excluded, if the damage to the product is recognized as warranty.
Technical specifications
Model
Measurements
Weight
Color
Material
Cord length
Input
Power
Number of heat settings
Timer
Automatic switch-off
Overheating protection
Cleaning
Certifications
Control
FM-18
180 x 130 cm
1.8kg
Grey / White
Flanel / Sherpa
240 cm (disconnection possible)
220V-240V 50/60HZ
135W
6
1-9 hours
After 180min (no timer set)
Yes
Suitable for hand washing only
CE, RoHS (LVD/EMC)
Controller with display and buttons
Caution! Make sure that the attachment in the
Contact / Information
Flow Motion
Info@flowm.nl
Langendijk 168
5045AW TILBURG
Chamber of Commerce: 81037228
VAT number: NL003520850B92
Disclaimer: Changes subject to change; specifications are subject to
change without notice.
Warning! The
Advertenties
