Inhoudsopgave
Advertenties
Steps
1. Place the system board on a clean and flat surface.
2. Install the
ethernet and audio
3. Turn the system board over.
4. Using the alignment posts, place the system board on the palm-rest and keyboard assembly, ensuring that the heat sink is
aligned against the top edge of the palm-rest and keyboard assembly.
5. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
6. Replace the five screws (M2x5) that secure the system board to the palm-rest and keyboard assembly.
7. Replace the screw (M2x3) that secures the USB board to the palm-rest and keyboard assembly.
8. Replace the screw (M2x3) that secures the ethernet and audio board to the palm-rest and keyboard assembly.
9. Replace the screw (M2x4) that secures the left fan to the palm-rest and keyboard assembly.
10. Align the screw holes on the Type-C bracket with the screw holes on the system board.
11. Replace the two screws (M2x5) that secure the Type-C bracket to the system board.
12. Connect the DDS (Dynamic Display Switch) cable to the system board.
NOTE:
This step is applicable only for computers that are shipped with a 165 Hz or 240 Hz display.
13. Connect the display cable to the system board and close the latch.
14. Adhere the tape that secures the display-cable connector latch to the system board.
15. Connect the power-adapter port cable to the system board.
16. Adhere the power-adapter port cable on the system board.
17. With both hands, use your fingertips to push the right-fan cable into its connector on the system board.
CAUTION:
Connecting the cable with the incorrect side facing upwards will cause damage to the connector
and the system board. Ensure that the black dot on the cable is facing upwards before connecting the cable.
18. Connect the speaker cable to the system board.
19. Connect the touchpad cable to the system board and close the latch.
20. Connect the keyboard cable to the system board and close the latch.
21. Connect the keyboard-backlight cable to the system board and close the latch.
22. With both hands, use your fingertips to push the left-fan cable into its connector on the system board.
CAUTION:
Connecting the cable with the incorrect side facing upwards will cause damage to the connector
and the system board. Ensure that the black dot on the cable is facing upwards before connecting the cable.
Next steps
1. Install the
memory
module.
2. Install the
wireless
card.
3. Install the
solid-state
4. Install the
rear
cover.
5. Install the battery.
6. Install the
base
cover.
7. Follow the procedure in
De systeemkaart verwijderen (toetsenbord met vier zones)
OPMERKING:
Deze procedure is alleen van toepassing op computers die met een vier-zonestoetsenbord worden geleverd.
Vereisten
1. Volg de procedure in
Voordat u in de computer gaat
2. Verwijder de onderplaat.
3. Verwijder de
batterij.
4. Verwijder de achterplaat.
board,
USB
board, and
drive.
After working inside your
FRU's (op locatie te vervangen onderdelen) verwijderen en installeren
fan and heat-sink
assembly.
computer.
werken.
71
Advertenties
Inhoudsopgave
