Inhoudsopgave
Advertenties
instructions for the 15-lnch Variable Speed Drill Presses
and 6 speeds drill press. This manual also includes parts
listings and illustra-tions of replaceable parts.
5. m
Refer to Figure 1 for key features of the drill press
achInedelen
Afbeelding 1
Figure 1: Drill Press Features
The base of the drill press has four mounting holes. The drill
press should be level and rest solidly on the floor. Place
shims under the four mounting holes in the base as
required to level the drill press.
.
Cleaning
LED Speed Display
Clean off any protective grease with solvent. After cleaning,
Speed setting handwheel
lubricate the base, table, and column with a light coating of
Motor
medium weight machine oil. Repeat at six months intervals.
On/Off switch
Intemal parts of the drill press are lubricated at the factory.
Head locking handle
No further lubrication is required at the time of installation.
Depth stop
Feeding handle
Electrical Connection
Spindle
Refer to the Wiring Diagram section for wiring information.
Column
Connection to electrical power should be made by a
Work table
qualified electrician. Observe local electrical codes when
connecting the machine.
Table height adjustment
The motor should be protected with a time delay fuse or
circuit breaker with a amperage rating slightly higher than
Rack
the full load current of the motor.
Base
Operating Controls
(Refer to figure 2)
ON/OFF Switch
The ON/OFF switch is located at the front of the drill head.
Speed Control Hand-wheel
CAUTION: TO AVOID DAMAGE TO THE SPEED
ADJUSTMENT MECHANISM, THE MOTOR
MUST BE OPERATING BEFORE ATTEMPTING
TO ADJUST THE SPEED SETTING.
The speed control hand-wheel is located on the left side
of the drill head. An LED speed indicator is provided on
the face plate on the drill head.
4
WIJZIGINGEN EN TYPEFOUTEN VOORBEHOUDEN
Toerentaldisplay
Handwiel snelheid
Motor
Aan/uit-schakelaar
Vergrendeling kop
Diepte-aanslag
Voedingshendel
Spindel
Kolom
Werktafel
(HU 16 F HS-4 Topline)
Tafelinstelling
(HU 16 F HS-4 Topline)
Tandheugel
(HU 16 F HS-4 Topline)
Voet
5
Advertenties
Inhoudsopgave
