Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Method 2:
Press + in the start screen of the AlectoCAM app to add a camera.
Now press QR Code.
The scanner of the smartphone or tablet (if supported) will be activated.
Now scan the QR Code applied to the camera.
The screen Add camera will open and here you can enter the password of the
camera ("admin").
Now press OK.
It might happen that the camera of the smartphone or tablet is not able to read the
QR code. In this case, press 'Cannot use QR code' in the bottom of the screen. In
the field UID, enter the UID code marked on the QR code sticker and then enter the
password "admin".
The camera is registered successfully when the image appears. Now press
Camera Settings and select Change the password and assign a unique password
to the camera. This is required for secure use of your camera.
2.4
TO REGISTER ON THE WIFI-NETWORK.
The camera must first be registered on your Wi-Fi network before you can use the
camera wirelessly on the Wi-Fi network.
Press the Advanced Settings ( ) in the app.
Go to the Wi-Fi Setup tab and then press this button.
The Wi-Fi band will now be scanned and all available SSID names will then appear.
Select and press your own network. Enter the password of your Wi-Fi network,
press OK and press OK again in the following screen.
Make sure to disconnect the power supply to the camera, remove the UTP network
cable and reconnect the camera to the mains.
Via the voice chip, the camera will indicate when it's ready and connected with the
network.
Advertenties
Inhoudsopgave
