Advertenties
Beschikbare talen
Beschikbare talen
OPERATIONS
Before you clean
Thoroughly sweep or vacuum floor prior to cleaning with the steam mop
Cleaning hard floors
Your steam mop is designed to clean hard flooring such as ceramic tile, vinyl, laminate, marble,
stone and sealed hard wood floors. Use of your steam mop on waxed or some unwaxed floors
may result in a diminished glossiness. The steam mop is not for inconspicuous area and check the
care instructions from your flooring manufacturer.
•
Plug the unit in and wait 30 seconds for it to heat up. Choose the level of steam to clean your
floor: Low(delicate floors). Medium(regular cleaning). High(durable floors or sticky messes).
Begin cleaning by slowly passing the unit over the floor surface.
*NOTE:
Press power switch before you press steam control. When you first press the steam level button,
the steam is at its maximum level. Please adjust desired level by pressing the button.
•
To turn off the steam mop, continue to press the steam level button until the blue light is illumi-
nated above the steam level button
•
When the steam mop mop stops emitting steam, unplug the unit. Simply remove the water
tank, refill and continue steaming,
NOTE: Be sure to disinfect the floor, use a microfiber mat and wipe it back and forth at least three
times with continuous steam. For beat results, remove the liner and clean it after.
operations
Carpet Glider
This accessory is used to attach the steam mop to allow the steam mop to slide over the carpet,
thus cleaning the carpet.
NOTE: Please make sure that carpet gilder has been buckled on the floor head. If it is not in the
correct position, it will cause carpet gilder to fall out during the use of the steam mop.
NOTE: Move the steam mop in a continuous motion until you are finished. DO NOT leave the mop
in a stationary position
19
Advertenties
