Advertenties
Beschikbare talen
Beschikbare talen
Positioning the remote control at Vortice ceiling fans of the NORDIK Series
receiver
downrod
canopy
Coding your FB-Powerboat
Receiver (sketch 4) and transmitter (sketch 5) must have the same code (1 - 4) setting!
Slide code switches to your choice of up or down position.(Factory setting is all „up").
Use a small screwdriver or ball point pen to firmly slide up or down! The 5th pole of code
switch is assigned as the special selection for light dimmer enable or light ON/OFF only
(i.e. for using ESL-bulbs or non dimmable LED bulbs).
Sketch 4
Battery Type: 23A
Attention:
The dimming of lamps that are not constructed for dimming will destroy the lamp and /
or the control electronics of your ceiling fan.
In this case, the damage is not covered by warranty!
A "flickering" during operation or irregular "flash" of the lamp when switched off is a
sure sign that lamp is not dimmable in this fan!
For ceiling fans of Vortices NORDIK
Series simply put the receiver into
the upper canopy. Put the antenna
wire into the upper canopy. Please
secure the canopy against sliding
downwards. Your ceiling fan with re-
mote control is ready to be used.
canopy
Sketch 5
GB
ON/OFF
DIM
5
11
Advertenties
