Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ARD-AYZ12
Installation Manual
This installation manual contains the following information:
-
Mounting Instructions
-
Wiring Instructions
-
Operation Instructions
-
Technical Specifications
MOUNTING INSTRUCTIONS
Installation Kit
The installation kit comprises of the following items that are to
be used during the installation procedure:
-
One installation template
-
Four pan head screws & wall plugs
-
One L shaped security screw tool
-
Three security screws
Mount the reader with the appropriate screws (not supplied) as
indicated on the template.
To mount the reader, perform the following:
1.
Determine an appropriate mounting position for the
reader.
2.
Peel off the back of the self-stick mounting label template
included with the unit and place at the desired mounting
position. If you do not have the self-stick mounting
template label, refer to the Mounting Diagrams in this
manual for the dimensions. When mounting the reader, you
must remove the snap-off cover to access the screw holes -
see Figure 1. Installing the unit on metal surfaces will
reduce the read range considerably. to decrease the affect
of the metal surface use the BOSCH ARD-MPZ02 spacer
(sold separately) as described in Figure 2 for a max range
of 17 inch (43 cm).
3.
Using the template as a guide, drill the holes (hole size is
indicated on mounting template) for mounting the reader
or spacer to the surface.
4.
Drill a
metal, place a grommet or electrical tape around the edge
of the hole and use the ARD-MPZ02 spacer.
5.
Route the interface cable from the reader to the controller.
A linear type power supply is recommended
Bosch Sicherheitssyteme GmbH
" (10 mm) hole for the cable. If mounting on
7/16
Installation Manual | en
| V 1.2 | 2009.09
5
Advertenties
Inhoudsopgave
