Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ADF-710 | ENGLISH
Call volume of the outdoor unit
To be able to set the call volume of the outdoor
unit, the outdoor unit must be opened. Remove the
front cover as described under "Mounting". There
are 4 screws under rubber feet (19) on the back.
First remove the rubber feet by levering them out
with a small flat-blade screwdriver. Then remove
the 4 screws. Now the enclosure can be taken apart.
Note: The front part of the housing has two cable
connections to the circuit board, 1x antenna and 1x
loudspeaker. If necessary, carefully disconnect both
connectors.
GB
On the circuit board there is a blue potentiometer
with which the call volume is adjusted. Be careful
not to over-tighten the potentiometer, it can be
turned a maximum of 320°.
When the volume has been adjusted to your
conditions, reassemble the front-door station in
reverse order.
Acknowledgement tone outdoor unit
Disassemble the outdoor unit as described in the
previous paragraph. There is a small switch on the
circuit board that can be used to turn the outdoor
unit's acknowledgement tone off or on. Slide the
switch towards the battery compartment to turn
the sound off or away from the battery
compartment to turn it on.
Call volume indoor unit
During a call, press the button volume + (8) to
increase the volume or the button volume - (9) to
decrease the volume.
Battery check
As soon as the upper battery control LED (2) on the
indoor unit flashes red during a call, the batteries of
30
Advertenties
Inhoudsopgave
