Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. OPERATION
You can control the hood by the switch on the hood or
by the remote control supplied.
Control on the hood:
① on/off control
② lower speed
③ display speed
④ increase speed
⑤ increase speed
3.1 Extraction
Switch on – switch off
To switch the motor on push button 1.
The hood will always resume the level it was previously
switched off in.
Switch off with 10 minute delay:
Press button 1 once. The currently set speed of the
motor flashes in the display. After 10 minutes motor
and illumination switch off automatically.
Switch off without delay:
Push button 1 twice.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours
(when no changes to the controls have been made).
Only the motor will turn off automatically. The lighting
will stay on.
Levels of intensity
To decrease speed levels push button 2. To increase
speed levels push button 4.
POWER' is only used in case of excessive formation of
smoke, fumes or odours. Taking into account the large
volume of air which is extracted from the room at this
level, it's use should be limited.
'POWER' automatically reverts to level 3 after 6 min-
utes.
A self-rectifying thermal contact makes sure that the
motor is switched off when overheated. The motor will
switch on again after is has cooled down. The cause of
the overheating needs to be determined. This may be,
for example, that the contents of the pan have caught
fire, the motor fan is blocked or an object is (partly)
closing off the exhaust opening.
3.2 Lighting
To activate the lights press button. The lights will switch
on at full power. Lighting can be activated indepen-
dently from the motor.
4 Maintenance
4.1 Grease filter
The hood contains two metal filters.
Grease filter indication
After 20 cooking hours, an [ F ] will start to blink on the
command, this indicates that the grease filter has to be
cleaned.
Access to the filter
Grip the glass plate (A) at the bottom left and right and
pull it forwards. Open the glass plate so that the grease
filter is visible. You can remove the metal grease filter
(B) from the hood.
Cleaning grease filters
The grease filter can be cleaned as follows:
• Manually: Immerse the filter in a solution of boiling
water to which a degreasing detergent has been
added. Then rinse the filters with warm water under
a tap and allow them to dry.
• In a dishwasher: use the lowest temperature and the
shortest programme. The filter can discolour some-
what in a dishwasher. This has no influence on the
working of the filter.
The previous instructions need to be followed. If
not an increased fire hazard may occur.
Reset grease filter indication
After cleaning the fat filter you can reset the timer by
pressing and holding the [ - ] key for 5 seconds. Now
the timer has been reset to 20 hours.
4.2 Maintenance of the hood
Please allow the lights to cool down sufficiently before
cleaning the hood. Use a soft, wet cloth and a mild
detergent to clean the hood.
Never use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel.
The stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.
EN 12
Advertenties
Inhoudsopgave
