Download Inhoudsopgave Inhoud Print deze pagina

Commissioning; First Charging; Radio Activation/Deactivation Of Motor; Use And Operating Mode - SOMFY Oximo WireFree Battery Installatiegids

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 35
Oximo WireFree™ Battery
2)
Wire the Oximo 40 DC RTS motor 4-pin connector to the
battery connector (B).
See the Oximo 40 WireFree™ RTS guide.
Caution! Never cause a short-circuit across the battery
terminals. Risk of burns and explosion.

5. Commissioning

5.1 First charging

Before commissioning the battery have it fully charged by a
professional, using the Somfy compatible external battery
charger (Oximo WireFree™ Power Supply, not supplied).
Caution! Any use of another battery charger is prohibited.
Do not exceed the maximum charging time of 3.5 hours.
See Oximo WireFree™ Power Supply guide.

5.2 Radio activation/deactivation of motor

The Oximo 40 DC RTS motor can be deactivated for trans-
portation, during extended periods of storage or when
commissioning another RTS motor nearby, using the batte-
ry's PROG button.
This limits battery discharge and eliminates any risk of
spurious operation of the roller shutters.
This function is operational after wiring.
To activate or deactivate the motor:
1)
Remove the battery's plastic cover on the cable side to
access the PROG button.
2) Press the battery's PROG button for a maximum of 1
second, then release it.
a)
If the roller shutter moves in one direction then a
second later moves in the other direction:
The battery has deactivated the motor: the roller
shutter does not move, whatever signals are sent by
the control points or associated sensors.
b)
If the roller shutter moves up and down briefly.
The battery has activated the motor: the roller shutter
moves according to the signals sent by the control
points or associated sensors.
3)
Refit the battery's plastic cover.
Note:After installing the roller shutter, check that the motor is
activated using the RTS control point.

6. Use and operating mode

6.1 Battery charging

After the Oximo 40 Wirefree™ RTS kit has been installed
and commissioned, the battery is charged with electrical
energy by the solar panel(s):
-
The electrical energy transmitted by the solar panel(s)
is stored by the battery to power the Oximo 40 DC RTS
motor.
20
2
B
1
2
PROG.
< 1 sec.
a
1 sec.
or
b
Copyright © 2009 Somfy SAS. All rights reserved.

Advertenties

Inhoudsopgave
loading

Inhoudsopgave