Advertenties
Beschikbare talen
Beschikbare talen
Fitting the camera
Creating a through-hole for the camera connection cable (fig. b, page 6)
I
NOTE
If possible, use available openings, such as ventilation grilles, to feed the connection
cables through. If there are no existing ducts, you must drill a hole of Ø 16 mm.
A
NOTICE! Beware of damage
Check beforehand that there is sufficient space on the other side for the drill head to
come out.
➤ Drill a hole with a Ø 16 mm at the previously marked duct.
➤ Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
Screw on camera using self-tapping screws (fig. c, page 6)
A
NOTICE! Beware of damage
Self-tapping screws may only be fastened to steel metal with a minimum thickness of
1.5 mm.
➤ Drill the holes, with a Ø of 4 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using 5 x 20 mm self-tapping screws.
Fitting the camera
A
NOTICE! Beware of damage
Only use the screws supplied to mount the camera. Longer screws will damage the
camera.
➤ Guide the camera cable into the vehicle interior.
➤ Slide the camera into the camera bracket.
➤ Fasten the camera loosely using the two screws M3 x 6 mm in the slots (fig. e, page 6).
➤ Provisionally align the camera, so that the lens is at an angle of approx. 50° to the vertical axis
of the vehicle (fig. f, page 7).
16
CAM45
EN
Advertenties
