Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7. Screw the lower hinge (2) into place on the bottom left side with the two screws (8).
8. Screw the foot(3) into place on the bottom left side.
9. Lower the door onto the lower hinge pin and align with the cavity opening in its closed position.
10. Remove the blanking plug from the hole on the top left of the door and transfer to the right side.
11. Screw the upper hinge (5) into place with screws (1) on the top left side of the cabinet.
12. Make sure the hinge pin on the top hinge locates in the hole in the top left of the door.
13. Make sure you have tightened all the screws securely.
14. Re-fit the top cover using the screws (6).
DEFROSTING
While the refrigerating unit is running, beads of condensation or hoarfrost from at the back of the
refrigerator compartment. This is normal. It is not necessary to wipe off the condensation or frost. The
rear panel defrosts automatically. The condensation runs into the condensation channel and is conveyed
to the refrigerating unit where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation can run out.
TIPS FOR SAVING ENERGY
For the most energy efficient use of your appliance:
x Ensure your refrigerator has adequate ventilation as recommended in the installation instructions.
x Allow warm food and drinks to cool down before placing in the appliance.
x Keep door openings to a minimum.
x Open the appliance as briefly as possible.
x Ensure that the refrigerator door is always closed properly.
OPERATING NOISES
Normal noises
x Motors are running.
x Refrigerant is flowing through the tubing.
GB-12
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
