Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Indicator statuses:
The charging process is indicated
by the flashing of the battery charge indi-
cator.
A solid light on the battery charge
indicator signals that the battery is fully
charged or that the temperature of the
battery is not within the permitted charg-
ing temperature range, and can therefore
not be charged. The battery is charged as
soon as the allowable charging tempera-
ture range is reached. When the battery is
not inserted, a solid light on the battery
charge indicator signals that the mains
plug is inserted in the plug socket and
that the charger is ready for operation.
7b
Following a successful charging proce-
dure, first disconnect the charger plug
from the power outlet, then remove the
battery from the charger.
7
Commissioning
ATTENTION!
DEVICE PROTECTION!
max. 45 °C
BEFORE COMMISIONING OBSERVE
CHAPTER 2 "FOR YOUR SAFETY".
Clean the roller/joint brush (O/K)
before each cleaning operation.
The air inlet openings on the
motor/gear unit (M) must not be
blocked or covered.
Check on a small, if possible hidden
area, that the ground to be cleaned
will not be damaged by the brushing
action.
Never use the device too long on
one spot, always guide at walking
pace.
7.1 Operation
Figures 8 - 11
8
Insert the charged battery into the bat-
tery adapter as shown until this engages
with a noticeable 'click'.
9
Always place the device parallel on the
ground which is to be cleaned. Identify
the most comfortable but also most
effective working angle for yourself
and then adjust the 5 click-stop safety
guard (P) so that the rubber lip is just
above the ground.
Make sure that the surface to be
cleaned is free from debris e.g. stones,
screws etc., which could be flung up.
CAUTION
RISK OF INJURY FROM ROTATING
BRUSHING TOOL!
Never start the device in a tilted posi-
tion!
Do not start or operate device if
bystanders are in the danger zone.
Never put your hands or feet near to
the rotating brushing equipment!
Never clean if others, in particular
children or animals, are in the area!
Never use the device in the rain.
10
You can regulate the speed of the
brush by pressing the speed control on
the adjustment wheel (T).
Speed recommendations for
GLORIA brushes
Position 1-2
soft brushes (wood brush)
Position 3-4
harder brushes (stone brush)
Position 5-6
joint brush (wire brush)
11
Hold the device securely by the handle
(A) and additional handle (F) and
switch on the device. To switch ON,
firstly press and hold the lock-off but-
ton (B) for ON/OFF safety switch (E).
Then press the ON/OFF safety switch
(E) and keep it pressed.
In case of work interruptions or
danger, release the ON/OFF safety
switch (E) immediately.
7.1.1 Battery status indicator
The device is equipped with a battery
charge indicator (C) that displays the
charging status of the battery. The dis-
plays only light up when the device is
switched on.
30
Advertenties
Hoofdstukken
Inhoudsopgave
