Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
the affected area thoroughly with
water and consult a doctor. Ensure
adequate fresh air and consult a doctor
if you experience irritation of respir-
atory tracts, skin or eyes.
2.3 Safety instructions for
operating the device
ATTENTION
Improper use of the device poses a
risk of damage to property! You should
therefore observe the following safety
instructions:
Do not use the device with wet hands.
Do not immerse the device in water
or spray or clean it with water.
The device must be protec ted
against moisture.
NEVER operate the device at tem-
peratures below 0° C.
OVERLOAD PROTECTION!
Your MultiBrush li-on PLUS has protection
against overloading. The unit switches off
automatically if you stress it excessively
(too much pressure on the brush). In this
case you should release the On / Off safety
switch (E) to reset the overload protecti-
on. Switching on again with the On / Off
safety switch (E) allows you to continue
working immediately with the MultiBrush
li-on PLUS. Reduce the force applied to
the brush by not pressing so hard.
TEMPERATURE PROTECTION
Your MultiBrush li-on PLUS has protecti-
on against excessively high temperatu-
res of the rechargeable battery. The bat-
tery cells can overheat if you use the unit
constantly over a longer period of time
or if it is exposed to high ambient tem-
peratures. Discharge is no longer poss-
ible above 70 °C. In such a case, the device
switches itself off automatically (all 4 dis-
plays flash, see also section 7.1.1). Allow
the rechargeable battery (D) to cool
down again before switching on again.
LOW VOLTAGE CUTOFF DEVICE!
Your MultiBrush li-on PLUS has a low vol-
tage cutoff device for the rechargeable
battery. This functions switches the unit
off immediately if the voltage falls below
a specified value (1 display flash, see also
section 7.1.1). In such a case you should
recharge the battery (D) or else put a
fully charged battery into the unit.
CAUTION
RISK OF BURNS CAUSED BY HOT
PARTS!
Parts of the device can become hot
during use and may cause burns.
It is therefore important to observe the
following safety instructions:
Wear protective gloves during
assembly and cleaning work!
Observe
the
precautions to prevent injuries and
material damage due to misuse and
unsafe handling of the product. Misuse
can result in INJURIES.
WARNING
RISK OF INJURY DURING OPERATION!
Use
the
device
Work only within the specified
perform ance range.
Before each use, make sure that the
device is in perfect condition;
operation is prohibited if:
- the safety devices (start switch,
protective covers) and/or brushes
are damaged or worn.
- the device shows visible signs of
damage.
- the device may have been
dropped before.
- foreign objects have wrapped
around the drive shaft.
Never disable any safety devices.
Check area to be cleaned beforehand
to avoid damage to device / objects
or injuries to living beings. Stones,
pieces of wood, wires or the like, as
well as other foreign objects must be
removed. Objects that are caught by
26
following
safety
as
intended!
Advertenties
Hoofdstukken
Inhoudsopgave
