Advertenties
Beschikbare talen
Beschikbare talen
For loop handle model
– Put the thread (1) on handle holder into the location hole (2) on tube.
– Fix the assistant handle (3) onto the barrier.
– Tighten the 4 bolts (4) M5 x 30.
Mounting the protector
To meet the applicable safety standards, you must only use the tool/protector
combinations indicated in the table.
Always use genuine DOLMAR cutter blades/nylon cutting head.
– The cutter blade must be well polished, and free of cracks or breakages. If the
cutter blade hits against a stone during operation, stop the engine and check
the blade immediately.
– Polish or replace the cutter blade every three hours of operation.
– If the nylon cutting head hits against a stone during operation, stop the engine
and check the nylon cutting head immediately.
Star Blade
CAUTION: The appropriate protectors must always be installed for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard installed is prohibited.
– Fix the protector (1) to the clamp (3) with two M6 x 30 bolts (2).
– When using the string head, fit the protector (6) into the protector (1), and
tighten them with two nuts (5) and two screws (4).
Protector for metal blades
(2)
(1)
Engine
Nylon cutting head
(6)
10
(4)
(3)
Engine
MS-27 C
Protector for cord cutter
(2)
(3)
(1)
(4)
(1)
(5)
Advertenties
