Advertenties
Beschikbare talen
Beschikbare talen
9. Blade
The 3-point blade is suitable for cutting brushwood and
small shrubs up to 2 cm in diameter. When the blade
becomes dull, it can be turned over to extend the life of
the blade. Do not sharpen the blade.
WARNING: Extreme care must be taken when
using blades to ensure safe operation. Read the
safety information for safe operation using the
blade, refer to"Specific Safety Rules for Brushcut-
ter and Blade Use" earlier in this manual.
•
Always hold brushcutter with both hands when oper-
ating. Use a firm grip on both handles.
•
Maintain your grip and balance on both feet. Position
yourself so that you will not be drawn off balance by
the kick-back reaction of the cutting blade.
11. TROUBLESHOOTING
PROBLEM
Line will not advance when
tap bump button
Bump head is hard to turn
Grass wraps around the
attachment shaft and the
trimmer head assembly
Unit stops and will not start
again
GB | Operating Instructions
POSSIBLE
• Line is welded to itself.
• Not enough line on spool.
• Line is worn too short.
• Line is tangled on spool.
• Grass wrapped or built up around
head.
• Cutting tall grass at ground level.
• Overload protection activated
• Fuse from main supply blown
• Unit failed
GB-11
•
Inspect and clear the area of any hidden objects
such as glass, stones, concrete, fencing, wire, wood,
metal, etc.
•
Never use blades near footpaths, fencing, posts,
buildings or other immovable objects.
•
Never use a blade after hitting a hard object without
first inspecting it for damage. Do not use if any dam-
age is detected.
•
The unit is used as a scythe, cutting from the right to
the left in a broad sweeping action from side to side.
10. Service
Servicing requires extreme care and knowledge and
should be performed only by a qualified service techni-
cian. For service we suggest you return the product to
your AUTHORISED SERVICE CENTRE for repair. When
servicing, use only identical replacement parts.
CAUSE SOLUTION
• Lubricate with a silicone spray
• Install more
• Pull lines while alternately pressing
down on and releasing bump button.
• Remove line from spool and
• Clean affected parts of the machine.
• Cut tall grass from the top down.
• Wait 10 minutes before restarting
• Check fuse
• Contact dealer to check damage
line.
rewind.
Advertenties
