Finish the „preparations".
Press On/Off button, the red LED lights up and the device starts the brewing process with
already selected strength of flavour.
At the end of the brewing process, the device switches itself off, then the red LED goes
out.
► The device is stopped when neither the red nor the white LED light up.
► The amount of brewed coffee may differ from the amount of water as coffee ground
absorbs different amount of water depending on the amount and degree of grinding of
the coffee ground
► The device is equipped with a drip stop system which enables you to serve coffee
before all the water has dripped through. Quickly put the insulated jug back in place to
avoid any overflowing.
► Do not fill hot water into the watertank.
► Never fill the water tank beyond top mark.
► Wait a few minutes before making another pot of coffee.
► The warming heatsup during brewing process. Danger of burns.
► Switch the device off when you have removed the last coffee from the coffee pot.
13.5 TIMER mode
Finish the „preparations". Press Prog button twice until TMER lights up.
Use the H button to set the hours and the Min button to set the minutes for desired start
time of brewing process.
After this press On/Off button twice until white LED lights up, then the TIMER mode is
activated. The device will start brewing process automatically when the programmed time
for the TIMER is reached. Then the white LED turns off and the red LED lights up.
► You can cancel the TIMER mode by pressing On/Off buton. The device is stopped
when neither the red nor the white LED light up.
13.6 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
13.7 Safety information
Attention
Please observe the following safety notices, before you commence with cleaning the
device:
► The device must be cleaned at regular intervals and limescale should be removed.
► Switch the device off prior to cleaning it and unplug the plug from the wall power outlet.
Please note
Warning
Please note
33