Dometic COOLAIR RTX1000 Montagehandleiding pagina 10
Montageset voor man tgx xxl
Verberg thumbnails
Zie ook voor COOLAIR RTX1000:
- Montagehandleiding (208 pagina's) ,
- Gebruiksaanwijzing (344 pagina's) ,
- Montagehandleiding (248 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
Installation
6.4
Preparing the unit
A
NOTICE!
When preparing the unit on the work surface, make sure it is secured against
falling off.
Make sure that the work surface is clean and level to ensure that the unit is not
damaged.
Proceed as follows (fig. 7):
➤ Place the parking cooler on a work surface with the casing facing down.
➤ Screw the 8 self-tapping M8 threaded plugs into the blind holes marked "1".
To do so, use the 1/4" bit supplied.
➤ Screw the 4 self-tapping M6 threaded plugs into the blind holes marked "7".
Use a 5 mm hexagon bit to do so.
6.5
Attaching the seal for the cab roof
A
NOTICE!
Ensure that the surface where the seal between the unit and the cab roof is to
be glued is clean (free of dust, oil, etc.).
➤ Glue the sealing strip to the cab roof (fig. 8 A).
Follow the contour of the roof hatch opening. The join between the ends of
the seal should be at the back.
➤ Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710) to the
join between the ends of the sealing strip and to the top edge of the sealing
strip (fig. 8 B).
6.6
Fitting the unit in the roof hatch
➤ Place the parking cooler centrally and facing forwards in the roof hatch
opening (fig. 9).
I
NOTE
Once the unit is in position on the vehicle roof, the seal should make contact all
the way round. Only then can a reliable seal be achieved.
A
NOTICE!
Do not exceed the specified tightening torque under any circumstances. That
is the only way to ensure that the threaded plugs are not pulled out.
➤ Fix the parking cooler in place as illustrated (fig. 0).
10
CoolAir RTX1000, RTX2000
EN
Advertenties
