Advertenties
Beschikbare talen
Beschikbare talen
en
Safety systems
Safety systems
Start lock-out
The appliance can only be switched on if
the bowl has been inserted and turned until
it locked into place, or if an accessory has
been secured to the main drive with the
bevel gear, and if the swivel arm is locked
into the lower position.
Automatic power-on safety lock
If the power is interrupted, the appliance
remains switched on, but the motor does
not start again when power is restored.
To switch back on, first turn the rotary
switch to y, and then switch on again.
Overload protection
The overload fuse will switch the motor off
automatically during operation. One pos-
sible cause may be processing too much
food at once.
Swivel arm protection device
The swivel arm will not unlock and move if
an accessory is fitted to the rear drive.
Troubleshooting
Note: The appliance will no longer
switch on if there is an error in appliance
operation, if the electronic fuses trip or the
appliance has a defect. First try to eliminate
the problem which has occurred with
the help of the following information.
Caution!
If a fault cannot be eliminated, please
contact customer service.
Fault
Appliance does not start.
Remedy
■ Check the power supply.
■ Check the mains plug.
■ Check the swivel arm.
Correct position? Locked into place?
■ Turn the bowl until the stop.
■ The automatic power-on safety lock is
activated. Turn the rotary switch to y
and then back to the required setting.
24
Fault
Appliance switches off during use. The
overload protection device is activated. Too
much food has been processed either at the
same time or for too long a period.
Remedy
■ Turn the rotary switch to y.
W Risk of injury!
Disconnect the mains plug.
■ Reduce the processing quantity.
■ Allow the appliance to cool down to
room temperature.
■ Do not exceed permitted maximum
quantities. X "Recipes" see page 22
Fault
The release button was inadvertently
pressed while the drive was running. The
swivel arm moves up. The drive switches off.
Remedy
■ Turn the rotary switch to y.
■ Press the release button and push the
swivel arm down until it locks into place.
■ Set the rotary switch to the required
speed again.
Advertenties
