Advertenties
Beschikbare talen
Beschikbare talen
For connection values, see type plate/technical
data.
Unwind the mains cable and place it on the
floor.
Insert the mains plug into a socket.
Water connection
Connection to the water supply
WARNING
Observe regulations of water supplier.
According to applicable regula-
tions, the appliance must never
be used with the drinking water
network without a system sepa-
rator. Use a suitable system separator as
per EN 12729 type BA. Water that has
flowed through a system separator is
classified as undrinkable.
CAUTION
Always connect the system separator to
the water supply, never directly to the
appliance!
For connection values refer to technical specifica-
tions.
Connect the supply hose (minimum length 7.5
m, minimum diameter 3/4") to the water con-
nection point of the machine and at the water
supply point (for e.g. a tap).
Note:
The supply hose is not included.
Open the water supply.
Drawing in water from open reservoirs
Screw the suction hose with filter (art. no.
0707 161 999) to the water connection.
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run until the
water exiting is bubble-free.
At the end let the appliance run for approx. 10
seconds - then switch off. Repeat the proce-
dure for a couple of times.
Switch off the appliance and fit the nozzle
again.
Operation
DANGER
Risk of explosion!
Do not spray flammable liquids.
If the appliance is used in hazardous ar-
eas (e.g. filling stations) the correspond-
ing safety regulations must be observed.
Risk of injury! Hold the hand spray gun
and the spray pipe firmly with both
hands.
CAUTION
Clean engines only at places with corre-
sponding oil separators (environmental
safety).
High pressure operation
Note:
The appliance is equipped with a pressure switch.
The motor starts up only when the trigger gun is
open.
Roll off the high pressure hose totally from the
hose drum.
Set the appliance switch to "I".
Unlock the trigger gun and pull the lever of the
gun.
Set working pressure and flow rate through
turning (runless) at the pressure- and amount
regulation (B) (+/-).
(No pressure/quantity control with the
HDR 160 Compact).
Select spray type
Close the hand spray gun.
Turn the casing of the nozzle till the desired
symbol matches the marking.
Flat low pressure spray (CHEM) for
operating using detergents or clean-
ing at low pressure.
High pressure flat spray (25°) for
large dirt areas
GB - 4
17
Advertenties
