Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Switch off the machine immediately after the cutting process!
Tool change
Attention!
The cutting and beveling disc as well as the fastening screw might heat
up enormously during operation. You could burn your hands or get cut
or ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
Loosen both wing nuts (A) and remove the beveling depth adjustment (B) as
well asthe cover plate (C).
Loosen the hexagon head screw (D) clockwise (left-hand thread!) with the
ring wrench (SW 11) while holding the outer flange (E) with the second ring
wrench (SW 19).
Remove the hexagon head screw, the outer flange, and the cutting and
beveling disc.
For changing, the cutting and beveling disc must be tilted at a slight angle.
To assemble the new cutting and beveling disc, proceed in reverse order.
Tighten the hexagon head screw again firmly in counterclockwise direction.
21
Advertenties
Inhoudsopgave
