Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
■
Always place the device on a dry, level and solid base.
■
Keep a suffi cient distance from other heat sources, e.g. hobs or ovens.
■
Never cover the device with cloths or the like. Danger of overheating!
■
The device should never be set up when highly fl ammable materials are nearby
(curtains, textiles, etc.).
■
Do not place any fl ammable materials such as paper, cardboard or plastic in or on
the device.
■
Never submerge the motor unit in water or other liquids! Make sure that the motor
unit, the cord or the plug can not fall in water or get wet.
■
If the motor unit falls in water, immediately disconnect the power supply.
■
Never touch the motor unit, the cord or the plug with wet hands.
■
Only connect the device to a socket, which has been properly installed and complies
with the device's technical data (see chapter "Technical data").
■
Lay the cord such that it is not crushed or creased and such that it does not come
into contact with hot surfaces.
■
Always set the rotary switch to the AUS (Off) position and pull the mains plug out of
the socket if a defect occurs while in use or before a storm.
■
If you want to remove the mains plug from the socket, never pull on the cable, but
always on the plug.
Beware of damage to the device and property
■
Check the device for damages prior to each use. Only use the device if it has been
completely assembled, is not damaged, and is fully functional!
■
Do not use any additional accessories. Only use the enclosed accessories from the
manufacturer.
■
Do not let the motor run if the device is empty.
■
Make sure that the maximum fi lling capacity (mark on the blending container) is not
exceeded!
■
Do not leave the device unattended when in operation.
■
The device must not be transported when switched on. Always pull the mains plug
out of the socket and allow the motor to come to a full stop prior to moving the device.
■
Do not allow the device to fall and do not subject it to strong percussions.
■
Do not subject the device to extreme temperatures, severe changes in temperature,
direct sunlight or moisture.
■
During operation, make sure the device has a stable position.
■
Always keep the lid of the blending container closed during preparation. You can
remove the insert in the centre of the lid to add ingredients during operation.
■
Use the device continuously for no more than 1 minute without stopping to prevent it
from overheating. Then, let the device cool off for a short time before using it again.
■
The motor unit is not suitable for cleaning in a dishwasher!
For your health
■
There may be some production residue stuck to the device. To avoid health risks,
clean it thoroughly before fi rst use (see chapter "Cleaning and storage").
All manuals and user guides at all-guides.com
12
Advertenties
Hoofdstukken
Inhoudsopgave
