Download Print deze pagina

Siemens TE506 Series Gebruiksaanwijzing pagina 25

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 69
Problem
Display shows
Check
water tank
The coffee grounds are not
compact and are too wet�
Display shows
Clean brewing unit
Coffee or milk froth quality
varies considerably�
Water dripped onto the
inner floor of the appliance
when the drip tray (8) was
removed�
Display shows
Insert brewing unit
Restore the unit to its
original factory settings
("Reset")�
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Cause
Water tank has been
incorrectly inserted or the
new water filter has not
been rinsed according to
instructions�
Carbonated water in the
water tank�
The grinding setting is too
fine or too coarse, or not
enough ground coffee has
been used�
Brewing unit (5) is soiled�
Too much pre-ground
coffee in the brewing
unit (5)�
The brewing unit's
mechanism is stiff�
Build-up of limescale in the
appliance�
Drip tray (8) removed too
early�
Brewing unit (5) is missing
or was not recognised�
You changed some
settings and want to
discard them�
Solution
Insert the water tank
correctly or rinse the water filter
according to instructions and then
switch on�
Fill the water tank with fresh tap
water�
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee�
Clean brewing unit (5)�
Clean brewing unit (5)�
Pour in no more than 2 level
measuring spoons of ground
coffee�
Remove and clean the brewing
unit, see "Maintenance and daily
cleaning"�
Descale the appliance as
described in the instructions�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8)�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance�
Turn off the unit with the power
on/off switch O / I (9)� Press and
e
j
hold the
off /
(13) and the
(12) button and turn the appliance
on with the power on/off switch
O / I (9). Confirm by pressing the
start button start (10)� The factory
settings are now activated�
en
de
h
21

Advertenties

loading

Deze handleiding is ook geschikt voor:

Te509 series