Coffee is brewed and then poured into the
cup(s)�
N.B.: With some settings the coffee is
prepared in two stages (see "aromaDouble
Shot")� Wait until the procedure is fully
completed�
Press the start button (10) again to cut the
brewing process short�
Preparation using
ground coffee
This fully automatic espresso machine can
also be operated with ground coffee (not
instant coffee powder)�
The appliance must be ready for use� To
prepare a coffee-based drink with milk,
first insert the milk tube into a milk container
and turn the rotary selector (6b) to "Milk
j
froth"
�
N.B.: The aromaDouble Shot function
cannot be used when coffee is prepared
using ground coffee�
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the
programme�
system
Important: Fill the water tank (17) with
fresh water every day� The tank (17) should
always contain sufficient water for operating
the appliance�
Preparation
1� Open the drawer (4)�
2� Pour in no more than 2 level measuring
spoons of ground coffee�
Warning: Do not use whole beans or
instant coffee�
3� Close the drawer (4)�
4� Select the required drink by turning the
5� Press the start button (10)�
Coffee is brewed and then poured into the
cup�
N.B.: Repeat the procedure for another
cup of coffee� If no coffee is taken within
90 seconds, the brewing chamber empties
automatically to avoid overfilling. The appli-
ance rinses�
Dispensing hot water
A
The milk frother (6) gets very hot� Hold the
milk frother (6) by the plastic part only�
The milk frother must be cleaned before
drawing hot water�
The appliance must be ready for use�
1� Place the pre-warmed cup or glass
2� Set the rotary selector (6b) to the
Clean milk
3� Press and hold the
4� Press the
upper rotary knob (15) (only one cup
possible)�
Risk of burns!
under the outlet of the milk frother (6)�
horizontal position�
for approx� 3 seconds� The appliance
heats up� Hot water runs out of the milk
frother outlet (6) for about 40 seconds�
h
g
/
button (12) again to
cut the process short�
en
de
h
g
/
button (12)
11