Set point button
Temperature
display window
Fig. 7
[c] DEFROST
The refrigerator/freezer automatically defrosts the
evaporator every 6 hours. The temperature display
window shows "dF" during defrost cycle. To start a
manual defrost cycle, hold down the two temperature
control buttons at the same time for a short time. The
next defrost cycle will begin in 6 hours.
[d] SHUT DOWN
1) Before shutting down the unit, move the stored
foods into another refrigerator/freezer.
2) Unplug the unit or disconnect the main power
supply.
3) When preparing the unit for long storage, clean
the cabinet interior and door gaskets, dry them
thoroughly and store the unit in a dry place.
III. MAINTENANCE AND CLEANING
INSTRUCTIONS
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, unplug the unit.
2. Do not touch or wet the machine compartment
parts. This could result in failure or breakdown.
3. To prevent possible damage, do not clean
the plastic parts with water above 40°C or in
a dishwasher.
Gram-webshop.nl
Temperature
control button
250V-10A
WARNING
1. INTERIOR, EXTERIOR, SHELF
* Clean the interior and exterior at least once a
week for sanitary use. The unit can be moved by
unlocking the castors [castor models].
* Clean off the interior and exterior with a soft cloth
soaked in cold or warm water containing the proper
amount of neutral cleaner and wrung dry. Do not
use a water jet to clean the machine compartment.
* Chemical agents other than neutral cleaner might
cause damage to the interior and exterior surfaces.
* The door gasket and its contact surface get
soiled easily. Clean every surface of these parts
thoroughly. Remnants of food will accelerate aging.
* Use a cloth to wipe off any water staying inside the
cabinet.
2. AIR FILTER
Plastic mesh air filters remove dirt or dust from the
air, and keep the condenser from getting clogged.
If the filters get clogged, the refrigerator/freezer's
performance will be reduced. Check the filters at
least twice a month. When clogged, use warm water
and a neutral cleaner to wash the filters. Do not
operate the unit with the air filters removed, or the
condenser will get clogged, resulting in failure.
1) Remove the air filter from the front panel.
2) Wash the air filter carefully with cold or warm
water containing the proper amount of neutral
cleaner. Rinse and dry the air filter thoroughly.
3) To refit the air filter, put the two tabs into the
bottom slots in the front panel, and tightly attach
the air filter over the entire slots by using the
magnet provided.
Front panel
Slot
Fig. 8
5
ENGLISH
Tab
Magnet
Air filter
Gram-webshop.nl