15.2 Cleaning
1. It is recommended to use the machine often to keep the motor clean and dry.
2. Please keep the device at a dry and wll ventilated place to avoid the motor from getting
wet and moldy.
3. Don't dip device into water. Only wipe it with a wet cloth. The other parts (spatula, lids,
etc.) can be directly cleaned with water.
4. The blades are very sharp. In order to avoid injury please put them under water tap to
wash them. Do not wash them by hand.
5. It is recommended to dismantle the blades and drop a little bit of edible oil to the blade
shaft to improve the lubrication.
6. Add warm water and detergent into the jug. Cover it with the lid and mix for 30 sec.
Rinse out with clear water.
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Security advices
Attention
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
16.2 Troubleshooting
Problem
The device does not
start.
The unit has shut down.
Attention
► If above mentioned steps don't solve the problem, please contact your customer
service.
17 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
Caso Standmixer MX1000
Solution
Please check whether the power plug is properly plugged.
Please check whether the assembly is done according to
assembly methods.
The overheat protection was activated.
Pull out power supply plug and wait for the motor to cool
(about 20 to 30 minutes), then use again.
33