Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
To generate a constant flow of steam without holding the trigger, press the steam trigger and then
slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn
the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger.
7.
With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping
the head of the steamer in contact with the fabric.
8.
Switch the appliance off (O) and unplug it.
9.
Stand the steamer on its base and allow it to completely cool off before storing. To avoid mineral
buildup, empty the tank after each use.
CARE AND MAINTENANCE
1.
Make sure steamer is off, unplugged and completely cool.
2.
Wipe all surfaces with a clean damp cloth.
3.
After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth. This
will help remove any residue left in the steam holes.
4.
To avoid mineral buildup, empty the tank after each use.
•
Wipe the lint attachment with a damp cloth to clean it.
TROUBLESHOOTING
Problem
Not enough steam or no steam is
coming out of the steamer.
Discoloured water is coming
through the holes and staining
the fabric.
Steamer is leaking or spitting.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
Possible Cause
The steamer is not heated to full
temperature.
There is not enough water in the
water tank.
The water pump hasn't been
primed.
Residue has built up in the water
tank.
Perfumed or scented additives
were used.
Steamer is not hot enough.
Water tank is running low.
5
Solution
Always allow steamer to preheat
at least 45 seconds.
Fill the water tank.
After preheating, always prime
the water pump by holding the
steam trigger until steam forms.
Empty the water tank after each
use. Only use distilled, filtered, or
purified water.
Never use perfumed or scented
additives.
Allow the steamer to heat for
about 45 seconds.
Fill the water tank.
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
UA
AE
Advertenties
Inhoudsopgave
