Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Tips for use
The device is not intended for continuous operation. The device was designed to
create air pressure – not an air fl ow. Please do not use the device for more than
60 minutes at a time, to avoid overheating and damage to the device. Then let the
device cool down for at least 15 minutes. We recommend fi rst fi lling a large-volume
item with air, in order to then generate the required pressure with the device.
Checking the air pressure with the Mini-Compressor
PLEASE NOTE: The pressure gauge with pressure display
Mini-Compressor
Connect the infl atable item to the connecting valve
„
, whose pressure you want to check. To do so, please proceed as
1
described in the section "Connecting the compressed air hose with a valve
adapter" or "Connecting the compressed air hose without a valve adapter".
The pressure gauge with pressure display
„
infl atable item connected.
Disconnect the infl atable item from the connecting valve
„
Mini- Compressor
"Removing the compressed air hose".
PLEASE NOTE: When disconnecting the connecting valve
escape from the valve on the infl atable item. Ensure that you remove the
connecting valve
Never use a fuse with a higher release current strength.
There is a risk of fi re!
z Replacing the fuse
ATTENTION: You must not use a fuse with a different release current
strength compared with the pre-installed fuse! Before switching the device back
on, ascertain why the fuse tripped.
In order to replace the 10 A glass fuse
as follows:
Unscrew the fuse screw plug
„
When doing this, make sure you do not lose the loosely inserted contact pin
„
and spring
16
is not trade-approved.
1
. To do so, please proceed as described in the section
1
as quickly as possible.
4
17
.
14
shows the pressure of the
2
in the cigarette lighter plug
15
. The fuse is located below this plug.
GB/IE/NI
of the
2
of the Mini-Compressor
4
of the
4
, air can
4
, proceed
7
17
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
