z Using the device
Take all parts from the packaging and check whether the device or parts show
any damage. If this is the case, do not use the device. Contact the manufacturer
via the indicated service address. Remove all protective films and other transport
packaging. Check that the delivery is complete.
For the device to operate properly, the socket for the electrical system must have
a voltage between 10.5 V and 14.8 V. Before connecting the device, check
whether the voltage supply provides sufficient power for operation.
z Using the Mini-Compressor
Place the product on a level and non-flammable surface.
Do not cover the ventilation openings.
Do not operate the device in a dusty environment.
This is a fire risk and the device could be damaged.
A gap of at least 50 cm must be maintained behind the ventilation slots of the
compressor.
Make sure that the product is switched off.
Connect the cigarette lighter plug
PLEASE NOTE: You can use the connecting valve
with the valve adapters supplied.
Connecting the compressed air hose without a valve
adapter
Undo the connecting valve
(see Fig. C for position).
Now push the connecting valve
(remove valve cap on the inflatable item first if necessary)
Then push the clamp lever
holding the valve firmly.
Connecting the compressed air hose with a valve
adapter
The valve adapters
First fit the required valve adapter
.
8
Push the clamp lever
Connect the valve adapter
inflatable item (remove valve cap on the inflatable item first if necessary).
to the 12 V socket of the cigarette lighter.
7
by pushing the clamp lever
4
over the valve of the inflatable item.
4
back down (see Fig. D for position) while
5
,
and
are located underneath the device.
11
12
13
,
11
downwards to fix the valve adapter in place (Fig. D).
5
,
or
11
12
13
directly or together
4
or
onto the compressed air hose
12
13
into the connecting valve on the
GB/IE/NI
upwards
5
15