Advertenties
Beschikbare talen
Beschikbare talen
Auxiliary Handle
3
2
The auxiliary handle (A) can be adjusted according to the application. For this,
use the supplied Allen wrench SW6 to loosen the screw (1). Set the auxiliary
handle to the desired position and tighten the screw again.
Switching on and off
B
Protective cover
Attention!
Before any work on the tool, disconnect the plug from the mains!
Operate the power tool only with installed protective cover and auxiliary handle.
The position of the protective cover on the machine can be adjusted according to the
application.
To do this, loosen the hexagon socket screw (G) on the clamping flange. Turn the
protective cover to the desired position and
Changing the Cutting Discs
Attention!
The Cutting discs, spacer discs and the flange nut might heat up
enormously during operation. You could burn your hands or get cut or
ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Attention!
Before any work on the tool, disconnect the plug from the mains!
Pay attention to the dimensions of the grinding tools. The mounting hole
diameter must fit the mounting flange without play. Do not use reducers
or adapters.
Before the initial commissioning, the auxiliary
1
handle (A) must be installed on the gearbox
housing with the cylinder screw (1), lock washer
(2) and washer (3).
Switching-on:
C
Switching-off:
First push ON/OFF switch (B) and
then push the safety lock (C).
Once the machine is running,
release the safety lock (C).
Release the on/off switch (B)
retighten the screw (G) firmly.
23
Advertenties
