Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
38
www.aeg.com
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
8.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
8.2 Setting and starting a
programme
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press the programme button
repeatedly until the indicator of the
B
30
20
C
programme you want to select starts
flashing.
4. Close the appliance door to start the
programme.
Starting a programme with
delay start
1. Set a programme.
2. Press the delay button to delay the
start of the programme by 3 hours.
The indicator
is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible
to change the programme.
When the countdown is complete, the
programme starts.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Do not try to close the
appliance door within 2
minutes after AirDry
automatically opens it, as
this may cause damage to
the appliance.
If, afterwards, the door is
closed for another 3
minutes, the running
programme ends.
Cancelling the delay start
Press the on/off button for 3 seconds
until the appliance is in programme
selection mode.
When you cancel the delay start, you
have to set the programme again.
Advertenties
Inhoudsopgave
