Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
TRAINING WITH HEART RATE
Hand sensors
This VirtuFit fitness machine is equipped with hand sensors to
measure heart rate. The hand sensors are attached to the handle
and only work if both sensors are held for a long time. For optimal
performance, it is important that the hands are slightly damp and exert
constant pressure on the sensors. Hands that are too dry or too wet
may result in abnormal readings.
MAINTENANCE
Safe and efficient use can only be achieved if the appliance is
properly installed and maintained. It is your responsibility to ensure
that the appliance is maintained regularly. Parts that have been
used and/or damaged must be replaced before the appliance is
used again. The appliance should only be used and stored indoors.
Long-term exposure to weather and temperature/humidity changes
can have a serious impact on the electrical components and moving
parts of the unit. Always unplug the power cord from the unit before
cleaning or servicing it.
Daily maintenance
•
Clean and remove sweat and moisture after each use.
•
Check that the unit is free of dust and dirt.
•
Do not use aggressive cleaning agents and keep the device
away from moisture.
Semi-annual maintenance
•
Inspect all bolts and nuts connected to the moving parts of the
unit. Tighten bolts and nuts as necessary and appropriate.
•
Check the mobility of moving parts and components of the unit.
Use silicone spray if necessary and appropriate.
We recommend the following:
•
Clean the unit after use.
•
Use a dry cloth to clean the control panel and the areas around
the on/off switch.
•
Use a soft, clean cloth and detergent to remove stubborn marks
and dirt from the unit.
•
Store the unit in a safe, dry place away from heat and water.
CAUTION!
•
Repairs must be carried out by a professional technician,
unless otherwise specified by the supplier or manufacturer.
Cleaning
General cleaning of the unit will extend its life. Keep the appliance
clean by dusting it regularly. Regular maintenance will prolong the life
of your appliance and prevent injuries! For more information, please
visit https://www.virtufit.nl/service/faq/
TROUBLESHOOTING
The display does not show any values: Check that the sensor and
console cables are properly attached and undamaged. If this does not
solve the problem, carefully bend the sensor.
Device squeaks: Check that all bolts and nuts are tight. If necessary.
The hand sensors are not working properly: Wash your hands, dry
them well and test the hand sensors again. If this does not solve the
problem, check the handlebar cables for damage and ensure that they
are properly connected to the connector. If this still does not correct
the problem, replace the handlebar.
Console does not work: If there is no signal, check that the cable is
correctly connected.
CONSOLE (FIG. A)
•
(1) MODE Press "MODE" to select functions. Press and hold
"MODE" to reset time, distance and calories.
•
(2) SCAN Press "MODE" until "SCAN" is displayed, the monitor
will cycle through all 6 functions: time, speed, distance, ODO,
calories, pulse. Each function will hold for 5 seconds.
(3) TIME Adds the total training time.
•
•
(4) SPEED Displays current speed.
•
(5) DIST Totals the total distance of the entire workout.
•
(6) CALORIES Totals the calories burned during the entire
workout.
•
(7) ODO The total distance covered by this function refers to
periods of battery power.
12
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
