Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
COMPONENTS (SEE PAGE 2)
Control panel
1
LED digital display
2
Front section
3
Pre-filter and principal filter
4
Tank
5
CONTROL PANEL (SEE PAGE 3)
Button ON/OFF
A
Button[ Speed ]
B
Button [ Oscillation ]
C
Button [ Mode ]
D
Button [ Timer ]
E
Button [ Cool ]
F
REMOTE CONTROL (SEE PAGE 2)
The remote control included a button cell battery (type CR2032 /3 V).
All the functions performed with the remote control. This remote control works like the control
display.
Button ON/OFF
A
Button[ Speed ]
B
Button [ Oscillation ]
C
Button [ Mode ]
D
Button [ Timer ]
E
Button [ Cool ]
F
USE PRECAUTIONS
• Make sure that the product is placed on a dry flat surface.
• Leave at least 50cm behind, around and in front of the appliance.
• Make sure the filter and the tank are correctly positioned and pressed.
12
Multidirectional wheels
6
Transport handle
7
Hand rotating flaps
8
Remote control
9
Ice box
10
Indicator light [ Natural Wind Mode ]
a
Indicator light [ Night Mode ]
b
Indicator light [ Low Speed ]
c
Indicator light [ MEDIUM Speed ]
d
Indicator light [ HIGH Speed ]
e
Indicator light [ Oscillation ]
f
Indicator light [ Cool ]
g
OPERATION PRINCIPLE
This product could be use like a classic fan or like an air cooler in activating the COOL function.
The air cooler Polair enable to cool down your room with a enjoyable temperature. The pump
system soaks the evaporating filter with the cold tank's water. The water content on this filter is
distributed on the room thanks to the ventilating system. In function the evaporating air cooler
humidify the ambient air.
Avoid an excessive humidity: we recommend humidity in a room between 45 and 55%. An
excessive humidity can cause health problems and damage your habitation.
OPERATING INSTRUCTIONS
1. Connect the device.
2. Press the ON/OFF button (
) to turn on the device. Polair goes on automatically in normal
A
speed and displays the room temperature. Press a second time to switch off the product.
3. Press the ON/OFF button again to turn off the device.
COOL FUNCTION
BUTTON [ COOL ]
For activating the cool mode press the button [COOL] (
this function. The cool function works with the others modes (show on the digital display
).
g
This function works only if the water level is enough. If the captor detect a lack water
during 15 sec the cool mode turn off and a warning signal turn on during 10 sec.
1. Push the tank and fill it with cold water. Be away that the water level is between the min
and max marks.
2. The ice box could be placed into the tank for a better cold air flow. Before using it place
it 4 hours in the freezer.
3. Push the tank into the product.
4. Plug the product.
5. Press the COOL button for starting the cool mode.
> In cool mode the product couldn't be use without the filters. Be away that the filters are
dry and well installed.
> Don't pull the tank when the cool function are activated.
> Condensation can be seeing on the floor with a use of the ice box. Please use Polair on
water resistant floor.
). Press a second time to turn off
F
13
Advertenties
Inhoudsopgave
