IE
NI
Adapter with threaded
connector
The adapter (25) is intended for use with
PARKSIDE high-pressure cleaners
PHD 100 A1, PHD 100 B2,
PHD 100 C2, PHD 100 D2,
PHD 150 A1, PHD 150 B2,
PHD 150 C2, PHD 150 D3.
1. Insert the adapter into the water con-
nection (15) on the handgrip (11) of
your telescopic tube. You will hear it
click into place.
2. Establish a water connection with your
high-pressure cleaner via the adapter
(25) on the water connection (15) on
the handgrip (11) of your telescopic
tube.
Quick-Connect adapter
(third-party devices)
Quick-Connect adapter (26) with securing
clip (27) for high-pressure cleaners
made by third-party manufacturers.
1. Insert the Quick-Connect adapter
(third-party devices) (26) into the water
connection (15) on the handgrip (11)
of your telescopic tube. You will hear it
click into place.
2. Remove by pulling the securing clip
(27) for the Quick-Connect adapter
(third-party devices) (26).
3. Establish a water connection with your
high-pressure cleaner via the adapter
(26) on the water connection (15) on
the handgrip (11) of your telescopic
tube.
4. Secure the connection by inserting the
securing clip into both holes of the
Quick-Connect adapter (third-party de-
vices) (26).
8
Using detergents
The pressure cleaner was designed for
operation with a neutral detergent based
on a biologically decomposable anionic
tenside. Other detergents or chemical sub-
stances could impair the safety of the pres-
sure cleaner and damage it. Such damage
to the equipment is not covered by the
guarantee.
Cleaning and
Maintenance
Always remove the mains plug of
the high pressure cleaner before
working on the device. There is a
risk of electric shock or injury from
moving parts.
Cleaning
Always keep the device clean. Do
not use any detergents or solvents.
•
Only clean the device with a soft brush
or a slightly moist cloth.
Maintenance
The device is maintenance-free.
Storage
•
Store the device in a frost-free room.