Advertenties
Beschikbare talen
Beschikbare talen
Adjustment of the slope nuts # from the steering wheels.
"
!
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
"
!
WARNING:
Risk of injury - Make sure that the eccentric screw settings are
identical on both front-wheel adapters and, before using the wheelchair.
This figure illustrates the principle. The position of the screw thread is indicated by a number.
3.4
Seat width adjustment
The wheelcair can be adjusted to seat widths of 390 mm to 500 mm (15.35 lb. to 19.69 lb.).
The straps on the seat and rear covers must be loosened completely beforehand. (see the
"#$%&'()*+,'$&-*$./*+0$12-34
4 x
B
4 x
A
Loosen the 4 locking screws on the spacer guide (these are located on the two top
A
and bottom ends of the cross-hinged tubing) with an appropriate Allen key.
Loosen the four Phillips screws alongside the locking screws on the brackets for the
B
hinged tubing. These are located on the top and bottom end of the cross-hinged
tubing.
Turn the disc screws on the two boomerangs so that they can telescope freely.
C
Pull the hinged tubing at each end to the required seat width. The cross-hinge
D
components have been drawn out to the required width when the required lengths
can be precisely seen in all four fields on the cross-hinged tubing and the Phillips
screws (B) engage on their own.
All manuals and user guides at all-guides.com
Shows the frame when the seat is horizontal and the
A
adapter is perpendicular to the ground.
B Shows the frame when the seat is tilted slightly and the
adapter is not perpendicular.
!
!"#$%&,%
Eclips+ AD
D
C
EN
2011-03
Advertenties
