Inhoudsopgave
Advertenties
1. Belt guard
2. Screw
3. Screw
4. Hairpin clip and retaining pin
5. Hex nut (located behind tire)
6. New tine
7. Worn tine
8. Sharp edge
9. Hairpin clip
10. Retaining pin
Figure 18
1
2
3
4
Figure 19
6
Figure 20
Tine
WWW.PlanDeGraissage.ORG
5
7
tine_3
Tine
3-1/2"
max.
49
Ground drive belt replacement
a. Remove hairpin clip and retaining pin (fi g. 18) from hub
of left hand wheel. Pull wheel out from tiller about 1-1/2
inches.
b. Remove belt guard by removing two (2) screws, one (1)
hex nut and three (3) washers so that belt guard can slide
straight out away from engine (fi g. 18).
c. Loosen belt guide (fi g. 17-inset)
d. Remove old belt by slipping from idler pulley (fi g. 17)
fi rst.
e. Place new belt in groove to transmission pulley (large pul-
ley) and into groove of engine pulley (fi g. 17). Belt must
be in groove on top of idler pulley (fi g. 17). Note positon
of belt to guides.
f.
Tighten belt guide (fi g. 17 -inset)
Tine replacement
A badly worn tine causes your tiller to work harder and dig
shallower. Most important, worn tines can not chop and shred
organic matter as effectively nor bury it as deeply as good
tines. A tine this worn (fi g. 19) needs to be replaced.
To maintain the superb tilling performance fo this machine the
tines should be checked for sharpness, wear and bending,
particulary the tines which are next to the trans mis sion (fi g.
20). If the gap between the tines exceeds 3-1/2 inches, they
should be replaced or straightened as nec es sary.
New tines should be assembled as shown in fi gure 21. Sharp-
ened tine edges will rotate rearward from above (fi g. 21).
CAUTION!
Never tamper with the engine governor, which is factory set
for proper engine speed.
Figure 21
8
10
5
Counter tine
rotation
9
tine 13
Advertenties
Inhoudsopgave
